NOTE: If you are replacing an element, per-
form steps 5 and 6. If you are replacing just a
limiter, proceed to step 7.
5.
With the wires connected to the termi-
nals, lift the old element out of the base,
and install the new one in its place with
the terminals positioned the same as the
old one.
LIMITER
Cooking Products Service Manual
Original April, 1996
© 1996 Whirlpool Corporation
6.
One at a time, disconnect the wires from
the terminals of the old element, and re-
connect them to the same terminal loca-
tions on the new one.
7.
Lift the element with the defective limiter
so you can access the bottom, and re-
move the screws from the old limiter, then
pull the sensing tube out of the element,
and remove the limiter.
ELEMENT
SENSOR TUBE
3-9
4321972
Page 3-9