Basic Connections - JVC YU30052-572 Instructions Manual

PLAYBACK

Basic Connections

To AUDIO
and VIDEO
connectors
A/V cable (provided)
A
To AUDIO and
VIDEO IN
If your TV/VCR
connectors
has the SCART
connector, use
the provided
cable adapter.
VCR
Aerial
To AUDIO, VIDEO and
DC OUT connectors
RF unit RF-V5E
(optional)
NOTES:
It is recommended to use the AC Power
Adapter/Charger as the power supply instead
of the battery pack.
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's power switch to CAMERA, then
set your TV to the appropriate input mode.
If you have a TV or speakers that are not
specially shielded, do not place the speakers
adjacent to the TV as interference will occur
in the camcorder playback picture.
There are three basic types of connections. When making
the connections, refer also to your VCR and TV
instruction manuals.
Connection To A VCR [A]
(Editing, Dubbing and Playback)
NOTE:
Use the provided A/V cable.
CONNECT CAMCORDER TO VCR
1
As shown in the illustration at left, connect the
provided A/V cable. between the AUDIO and
VIDEO connectors on the camcorder and those on
the VCR.
B
SUPPLY POWER
2
Turn on the camcorder, the VCR and the TV.
SELECT MODE
3
Set the VCR to its AUX input mode, and set the TV
to its VIDEO mode.
Connection To A TV With A/V Input
Connectors [B] (Playback ONLY)
NOTE:
Use the provided A/V cable.
CONNECT CAMCORDER TO TV
1
As shown in the illustration at left, connect the
provided A/V cable. between the AUDIO and
VIDEO connectors on the camcorder and those on
the TV.
SELECT MODE
2
Set the TV to its VIDEO or AV mode (as specified in
its instructions).
Connection To A TV With NO A/V Input
Connectors (Playback ONLY)
NOTE:
Use the optional RF-V5E RF unit.
* Refer to the RF-V5E instruction manual for connection
procedure.
33
EN