Table of Contents
Advertisement
Setup
3. Setup
AC Power
AC Plug
Fuse Replacement
-6-
Each STRIKE™ 324 has an auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each
STRIKE™ 324, refer to the label affixed to the product. You can also refer to the
Technical Specifications
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the Chauvet
website: www.chauvetlighting.com/download/pro.
· Always connect this product to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire.
· To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
The STRIKE™ 324 comes with a NEUTRIK® powerCON A connector on one end and
an Edison plug on the other end (US market). If the power cord adapter that came with
your product has no plug or you need to change the Edison plug, use the table below to
wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
Make sure to disconnect the product's power cord before replacing a blown fuse.
Always replace the blown fuse with another of the same type and rating.
1. Disconnect this product from the power outlet.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with another fuse of the same type and rating
(T 3.15 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
chart in this manual.
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Screw Color
Brown
Yellow or Brass
Blue
Green/Yellow
STRIKE™ 324 User Manual Rev. 3
Silver
Green
Advertisement
Table of Contents
