EPOX EP-61BXA-M Manual page 24

Installation
The EP-61BXA-M uses the Single Edge Contact (SEC) slot for a Pentium II proces-
sor packaged in an SEC cartridge. The SEC slot is not compatible with other non-
Pentium II processors.
Please have ready the following list of components so that we may install the proces-
sor onto the motherboard.
1. Heat sink support (top/bottom piece)
2. Pentium II processor heat sink
3. Intel Pentium II Processor
OK, now that you have all of your components ready, we can start.
First, please refer to figure 8 below, and follow the direction to lift up the fixed
®
foldable pentium
designed for you to install Pentium
damage on the board due to overtightening the four screws.
One thing must be kept in your mind that please make sure to lift upright the
foldable parts of the Retention module to fit and install CPU properly.
Now we are going to install the heatsink support base piece (figure 9) onto the
motherboard. There is both a large and small hole (figure 10) so that the base will
only fit in one direction. This piece needs to be pushed into the holes firmly until it is
seated.
Now we are ready to install the SEC Cartridge (Pentium II Processor) into the
Retention Module. The SEC Cartridge is mounted by sliding the SEC Cartridge into
the Retention Module and letting it slide all the way down. Once it reaches the
Page 3-8
II Retention Mechanism. This pre-installed device is
®
II CPU more easier and to avoide any
Figure 8
EP-61BXA-M