Page 2
Affiliate with the N.V. KEMA in The Netherlands CERTIFICATE Certificate Number: 510040.001 The Quality System of: Grass Valley, Inc. 400 Providence Mine Road 15655 SW Greystone Ct. 10 Presidential Way Nevada City, CA 95945 Beaverton, OR 97006 Floor, Suite 300...
Preface This manual describes the features of a fiber optic submodule option in the Kameleon Media Processing System and the 8900 Series used in the GeckoFlex frame. Refer to the laser compliance information in the GeckoFlex Frames Instuction Manual for safety information As part of this module family, it is also subject to Safety and Regulatory Compliance described in the 2000 Series and 8900 GeckoFlex frame and power supply documentation (see the 2000 Series Frames Instruction Manual...
• 1310NM-DRL – Dual receiver (2 inputs), • 1310NM-DTL – Dual transmitter (2 outputs), or • 1310NM-TRL – Transceiver (1 input/1 output). The fiber ready modules currently available in the Grass Valley Kameleon 2000 and GeckoFlex 8900 Series are listed below: Kameleon 2000 Fiber Ready Modules •...
Kameleon 2000 Fiber Ready Modules Kameleon 2000 Fiber Ready Modules This section describes the installation and cabling of the SFP fiber optic sub- modules for the fiber ready modules in the Kameleon 2000 Series. Installation CAUTION The Fiber Optic submodule is static sensitive. Use static handling precautions when installing or removing the submodule.
2000 frame. Cabling to each of the submodule types is described below. Dual Optical Receiver With a dual optical receiver (1310NM-DRL) submodule installed, one of the optical inputs can be configured as the module input (instead of the coax BNC).
Kameleon 2000 Fiber Ready Modules Dual Optical Transmitter With a dual optical transmitter (1310NM-DTL) submodule installed, the output signal can be accessed from both optical outputs, Optic 1 (left) and Optic 2 (right), in addition to the coax BNC outputs. With the submodule handle in the up position, connect optical cables to one or both outputs as shown in Figure...
GeckoFlex Fiber Ready Modules GeckoFlex Fiber Ready Modules This section of the manual describes the installation and cabling of the SFP fiber optic submodule for the fiber ready modules in the GeckoFlex 8900 frame. The front and rear modules must be installed first according to the instructions in the specific GeckoFlex 8900 manual.
Configuration Configuration Once the submodules have been installed and cabled, refer to the specific 2000 and 8900 module instruction manuals for configuration and operation information. In most cases, the fiber inputs and outputs must be enabled using onboard local controls or through the web page GUI. Manuals are available on-line at no cost at this link: http://www.thomsongrassvalley.com/docs/ From this location, select...
2000 module on 8900 module configuration web site documentation web site FAQ database web site Grass Valley documentation online web site software download FAQ database fiber ready modules Gecko Flex 8900 Series Kameleon 2000 Series frequently asked questions...
Page 18
Index SFP Optical Converters — Installation Manual...