Maintenance (Hvlp Machine, Air Hose And Spray Gun) - Norvell M1000 Instruction Manual

6 Maintenance
1 Norvell M1000 HVLP Turbo
a. The only maintenance necessary on the HVLP Turbo unit is cleaning and/or changing the filter element. The
filter should be removed and rinsed out at least once daily or at least every 4 tanning sessions. The filter
housing and filter are located on the under side of the M1000 HVLP Turbo Unit.
b. To clean the filter, (See Figure 1)
c. Place the M1000 HVLP Turbo unit on one side at a time. Using a small screwdriver insert the blade into the
slot and push down and out at the same time. (See Figure 2-Do this on both sides)
d. Using your thumb and index finger, pull the filter housing out. (See Figure 3)
e. Pull the filter out of the filter housing to clean. (See Figure 4 & 5)
Air Filter
Fig 3
2 Air Hose.
a. Wipe the air hose daily with a damp cloth and store in a clean dry place.
3 Spray Gun
a. It is important to clean your Spray Gun daily.
b. At the end of the day or when the equipment will not be used any more, disconnect the Spray Gun from the
air hose.
c. Carefully unscrew the cup. If there is remaining solution, either close the cup with a cup lid, or pour the
remaining solution into a proper storage container.
d. Rinse the cup under warm running water until clean.
Fig 1
Fig 4
10
Fig 2
Fig 5