Advertisement
6
Maintenance Cont'd.
e. Fill the cup about ¼ full with water. Reconnect Spray Gun to Air Hose. Turn on the M1000 HVLP Turbo Unit.
Direct the Spray Gun to a safe area and spray the clean warm water through the Spray Gun until the cup is
empty.
f.
Turn off the M1000 HVLP Turbo Unit. Disconnect the Spray Gun. Unscrew the cup.
g. Wipe all exposed areas dry.
h. Unscrew and remove the Air Cap Ring (#1). Rinse the threads under warm running water. Wipe, clean the
threads and dry. Add a small amount of Spray Gun lube to the threads.
i.
Remove the Air Cap (#2). Rinse under warm running water. Wipe, clean and dry.
j.
If necessary, remove Air Distributor Plate (#5). Rinse under warm running water. Wipe clean, dry and
lubricate with Spray Gun lube.
k. Reinstall the three pieces you just removed by reversing the removal procedure. Your Spray Gun should be
ready for the next use. Store the Spray Gun in the holder on the M1000 HVLP Turbo Unit.
l.
The Solution nozzle (#3) can be removed for additional cleaning if necessary. Be careful. There is a Solution
nozzle gasket (#4) around the threads of the Solution nozzle. Be sure to reinstall or leakage will occur.
Removal of the Solution nozzle is not necessary on a daily basis. You should however remove it once a
week and rinse under running water. The Solution nozzle can be easily removed with an adjustable wrench
or spanner. Place the tip of your adjustable wrench or spanner on the two flat areas of the nozzle and twist
anti or counter clockwise.
m. The Solution needle (#10) can also be removed for additional maintenance. To remove: Turn the Solution
Flow Screw anti or counter clockwise until it comes out of the Spray Gun. Be careful when removing the
Solution Flow Screw as there is a small spring (#9) around the needle. Do not lose it. This is important to the
operation of the Spray Gun. Set the spring aside and pull the trigger all the way back until you can grab the
needle with your finger tips and pull it out from the back of the Spray Gun. Once removed, rinse under warm
running water, Clean and dry. Reinstall reversing the removal procedure. NOTE: Occasionally it is
necessary to lubricate the needle (#10) where it slides through the gland nut (#7). Simply rub a few drops of
Spray Gun lube around the needle shaft and reinsert into the back of the Spray Gun.
11
Hide quick links:
Advertisement
