Advertisement
3
Prepare the M1000 Spray Gun Cont'd.
1. Follow the diagram to prepare the Spray Gun
a. Unscrew the plastic cup from the Spray Gun. Pour Norvell sunless tanning solution into the cup. Do not
fill more than ¾ full.
b. Carefully screw the cup back onto the main body of the Spray Gun. Screw the cup on firmly but DO NOT
over tighten. Over tightening will cause the cup to "pop" and damage the threads. Leakage will
require replacement of the cup.
c. Locate the air cap (#2) on the M1000 SPRAY GUN diagram. Slightly turn the air cap ring (#1) anti or
counter clockwise to loosen the air cap. Notice that you can now rotate the air cap freely.
d. Look at Spray Gun Patterns diagram below. Note the position of the air cap and the direction of the spray
pattern. Pattern 1 is for spraying across from side to side. Pattern 2 is for spraying up and down.
Pattern 3 will produce a spot or circle. Patterns 1 and 2 are the most common positions for applying
tanning solutions.
e. Turn the air cap (#2) to the position you want. Turn the air cap ring (#1) clockwise to lock the air cap in
place.
2. Next, position the M1000 HVLP Turbo Unit as far away as practical and possible from the area where you will
spray.
3. Attach the remaining end of the hose to the M1000 Spray Gun as follows:
d. Locate the coupler at the rear top of the M1000 Spray Gun. See SPRAY GUN diagram.
e. Pull back on the collar of the black connector on the air hose.
f.
Push the connector over the coupler and release. Figure 7.
g. Your Spray Gun should now be firmly attached to the air hose.
SPRAY GUN PATTERNS
1. Spraying across from side to side
2. Spraying up and down.
3. Spraying in a spot or circle
7
Hide quick links:
Advertisement
