Proxxon TG 250 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Proxxon Manuals
  4. Sander
  5. TG 250 E
  6. Operating instructions manual

Proxxon TG 250 Operating Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

ProxxonTools.com
TG 250/E
Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TG 250 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Proxxon TG 250

Summary of Contents for Proxxon TG 250

  • Page 1 ProxxonTools.com TG 250/E Manual...
  • Page 2 Fig. 1 ø 4,5 mm 135 mm Fig. 2 - 2 -...
  • Page 3 Fig. 3 Fig. 4 Fig. 5 90° Fig. 6 - 3 -...

  • Page 4: Safety Regulations

    1. Ensure the workplace is tidy. Dear customer! 2. Check the unit for damage before use. The Proxxon TG 250/E disk sander is a high-quality tool for accurate sanding of a wide variety of materials. Please 3. (connection cable, protective devices, etc.), have read the enclosed safety guidelines and operating instruc- defective parts replaced by qualified personnel.

  • Page 5: General Safety Instructions

    General safety instructions 17. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recommended accessories. The use of improper accessories may cause risk of injury to Read and become familiar with this entire instructions persons. manual. Learn the tool`s applications, limitations and 18.

  • Page 6: Grounding Methods

    Legend (fig, 1) 2. Grounded, cord-connected tools intended for use on a supply circuit having a nominal rating less than 150 volts: This tool is intended for use on a circuit that has an outlet 1. Speed controller that looks like the one illustrated in Sketch A in Figure 7. 2.

  • Page 7: Technical Data

    Technical data 3. Grind a piece of wood and check the angle, if necessary readjust the working table 3 (fig. 1) and the indicator 12. Grinding speed: 250 - 750 m/min Abrasive disk: Ø 250 mm Replacing the Abrasive Disk Max.

  • Page 8: Liquid Cooling System

    Note: With horizontally set working table When applying the abrasive disk on the grinding plate, start from the centre and work outwards. 1. Release the clamping bolt 2 (fig. 6) and set the working table horizontally (indicator at "0"). 3. Apply the top half of the abrasive disk on the grinding 2.

  • Page 9: Cleaning And Care

    Any attempt to repair or replace electrical parts on this disk sander may create a hazard unless repair is done by a qualified service technician. Repair service is available at your PROXXON service center (You find the address at address at the back of this manual) - 9 -...

This manual is also suitable for:

Tg 250/e

Table of Contents