Download Table of Contents Print this page

Makita AN901 Instruction Manual

Construction coil nailer
Hide thumbs Also See for AN901:

Advertisement

INSTRUCTION MANUAL
Construction Coil Nailer
AN901
005459
IMPORTANT: Read Before Using.
1

Advertisement

Table of Contents
loading

Summary of Contents for Makita AN901

  • Page 1 INSTRUCTION MANUAL Construction Coil Nailer AN901 005459 IMPORTANT: Read Before Using.
  • Page 2: Specifications

    EC Declaration of Conformity to EN792: Makita Corporation responsible Sound pressure level (L ) : 87 dB(A) manufacturer declare that the following Makita Sound power level (L ) : 100 dB(A) machine(s): Uncertainty (K) : 3 dB(A) Designation of Machine: Construction Coil Nailer Wear ear protection Model No./ Type: AN901...
  • Page 3: Important Safety Instructions

    • Tomoyasu Kato Always assume that the tool contains Director fasteners. Makita Corporation Do not point the tool toward yourself or 3-11-8, Sumiyoshi-cho, anyone whether it contains fasteners or not. Anjo, Aichi, 446-8502, JAPAN Do not activate the tool unless the tool is placed firmly against the workpiece.
  • Page 4 • − fitting transportation safety systems e.g. on Makita. vehicles and wagons. Ask Makita's Authorized service centers for • Do not permit those uninstructed to use the tool. periodical inspection of the tool. • Make sure no one is nearby before nailing. Never To maintain product SAFETY and RELIABILITY, •...
  • Page 5: Installation

    CAUTION: INSTALLATION Low air output of the compressor, or a long or • Selecting compressor smaller diameter air hose in relation to the nailing frequency may cause a decrease in the driving capability of the tool. L/min Lubrication To insure maximum performance, install an air set (oiler, regulator, air filter) as close as possible to the tool.
  • Page 6 Attach the nose adapter to the contact arm. When not in 1. Latch lever use, store the nose adapter at the rear of the tool to keep 2. Door it from being lost. 3. Magazine cap 1. Contact arm 2. Nose adapter 005464 Lift and turn the coil support plate to set it to the correct step.
  • Page 7: Operation

    B. Pull the trigger fully and hold it on for 1-2 seconds 1. Air fitting after nailing. 2. Air socket For No. 1 method, set the change lever to the "Intermittent Nailing" position. For No. 2 method, set the change lever to the "Continuous Nailing" position. After using the change lever to change the nailing method, always make sure that the change lever is properly set to the position for the desired nailing method.
  • Page 8: Maintenance

    Hook 1. Hook Humid 005382 MAINTENANCE 005474 CAUTION: Always disconnect the hose before attempting to • perform inspection or maintenance. Never use gasoline, benzine, thinner, alcohol or the • like. Discoloration, deformation or cracks may result. Maintenance of nailer 005475 Always check the tool for its overall condition and loose The hook is convenient for hanging the tool temporarily.
  • Page 9 Maintenance of compressor, air set and air Stove hose Thinner 1. Drain cock 005390 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance and adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. 005387...
  • Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884286B228...

Table of Contents