Configuration; Access Point Mode - D-Link DAP-1155 User Manual

Section 3 - Configuration

Configuration

This section will show you how to configure your new D-Link wireless access point using the web-based configuration utility.

Access Point Mode

Change the mode selector to AP on the device. Connect an Ethernet cable from the Ethernet port on the DAP-1155 to a
computer for configuration.
If you wish to change the default settings or optimize the
performance of the DAP-1155, you may use the web-based
configuration utility.
To access the configuration utility, open a web browser
such as Internet Explorer and enter http://dlinkap or
http://dlinkap
http://192.168.0.50 in the address field.
Type admin and then enter your password. Leave the
password blank by default.
If you get a Page Cannot be Displayed error, please refer to
the Troubleshooting section for assistance.
D-Link DAP-1155 User Manual 11