Canon Legria mini Instruction Manual page 58

Basic Recording
• Observe the following precautions while the ACCESS
indicator is on or flashing. Failing to do so may result in
permanent data loss or damage to the memory card.
- Do not remove the memory card.
- Do not disconnect the power source or turn off the
camcorder.
- Do not press the ^ button.
• Be sure to save your recordings regularly ( • Be sure to save your recordings regularly ( • Be sure to save your recordings regularly (A 129),
especially after making important recordings. Canon especially after making important recordings. Canon especially after making important recordings. Canon
shall not be liable for any loss or corruption of data. shall not be liable for any loss or corruption of data. shall not be liable for any loss or corruption of data.
• If a subject is too close to the camcorder, it may not be • If a subject is too close to the camcorder, it may not be • If a subject is too close to the camcorder, it may not be
able to focus correctly. You can set the shooting mode able to focus correctly. You can set the shooting mode able to focus correctly. You can set the shooting mode
to
tance of only 20 cm from the camcorder. tance of only 20 cm from the camcorder. tance of only 20 cm from the camcorder.
• If 1
the camcorder will shut off automatically to save power the camcorder will shut off automatically to save power the camcorder will shut off automatically to save power
when it is powered by a battery pack and is left without when it is powered by a battery pack and is left without when it is powered by a battery pack and is left without
any operation for 3 minutes. Should this happen, set any operation for 3 minutes. Should this happen, set any operation for 3 minutes. Should this happen, set
the power switch to OFF and then ON again to turn the
camcorder back on.
(A 88) to be able to focus a subject at a dis- 88) to be able to focus a subject at a dis- 88) to be able to focus a subject at a dis-
> q q q > > >
[Auto Power Off] is set to [ [Auto Power Off] is set to [ [Auto Power Off] is set to [i On],
58