WARNING: Pregnant, or possibly pregnant, women should consult a physician before using a spa or hot tub. WARNING: Water temperature in excess of 104° F or 40° C may be injurious to your health. VITA SPA DUET...
Common Water Problems Priming Your Spa Common Hardware Problems Pr Message Spa Soaking Guidelines 300 Series System Wiring Diagram Powerworks® 300 Control System Operating Instructions Safety sign User’s Pads Limited warranty summary Temperature Controls Copyrights and trademarks VITA SPA DUET...
Unconsciousness resulting in the danger place. Extended operation can cause heat of drowning. build-up and interfere with spa operation. WARNING - The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia. VITA SPA DUET...
6. Spas should be double checked for leaks Outdoor Installation before installing to avoid possible water The following considerations apply when damage. Dealer installation may include installing your spa outdoors: this service. VITA SPA DUET...
Page 8
It is NOT recommended that you operate your fi lter cycles for longer than 4 hours per day under these conditions. SEE THERMAL CREEP: page 24 VITA SPA DUET...
(ampere rating and ampere requirements) (not shown). D. Equipment Pack Service Panel (no user serviceable parts): Spa support system consisting of pump, heater, and associated electrical controls (not shown). VITA SPA DUET...
Quantity will vary depending on model. All should be open during normal operations. D. Spa Pack: Houses the electronic circuit board. All equipment and incoming power connections are made here . VITA SPA DUET...
Turn the control counter- clockwise to turn the air off and clockwise to turn air on. NOTE: Air controls should be closed during heating cycles for maximum energy effi ciency. VITA SPA DUET...
To make spa electrical connections, remove The Model Duet comes factory set for 120 the exterior equipment pack service panel, volt service. locate the electrical control box, remove...
N.E.C. Article 680 and all local codes. CORD CONNECT The Vita Spa Duet Model comes with a power 1. Push the “TEST” button on the GFCI breaker. cord which contains the GFCI breaker. All...
4 minutes or press any thermal cover on the unit and close the air temp related button to exit Priming Mode. control to help the heating process. Important: Do not operate the spa without full water fl ow. VITA SPA DUET...
Note: In event of a power outage or failure, • Activate therapy pump the 300 Series Control System may retain • Set duration of fi lter cycles settings. If settings are lost, re-program per Jets the instructions in this manual. VITA SPA DUET...
Pump 1 The pump will operate either during a normal Touch the ‘JETS’ pad to activate the primary fi ltration cycle or, the heater and pump will be activated when the heater housing VITA SPA DUET...
9:00 PM,turn off the spa breaker and turn it back on at 8:54 PM (remember NOTE: When power to the spa is denied (disconnect, power outage), the controls may revert to the default factory settings. VITA SPA DUET...
Mode Mode Shuts off in... Shuts off in... Automatic Time Outs Pump 1 2 hours Your Vita Spa is equipped with an automatic Pump 1 High 15 minutes Time Out feature designed to protect both the Light 4 hours equipment and the user. To reduce unneces-...
3.0 to 5.0 Ozonator is a smart decision. The use of ozone ppm. in conjunction with spa sanitizing and water balancing chemicals helps to provide you with a cleaner, healthier spa and reduces chemical usage. VITA SPA DUET...
NOTE: It is advisable to drain your spa and refi ll it with fresh water every six to eight Duet model spa should run and be ozonated a minimum of 4 hours per day. If your spa is weeks or more often, depending on the heavily used, this time should be increased.
5. Soak fi lter in a commercial fi lter cleaner/ degreaser, available from your Vita Spa dealer, per manufacturer’s instructions. Hose out fi lter cartridge or replace with new cartridge, if needed.
Page 23
• Reconnect the plumbing to the heater, the freeze plugs and the lower of the two connections on your pumps. • Add RV antifreeze to the pump using your f unnel. Most pumps will take approx. 4 oz. VITA SPA DUET...
Then take a wash cloth and wipe down Remove dust and dry dirt with a soft, damp each foam core. Rinse both well. Place the cloth. Avoid using razor blades or other sharp VITA SPA DUET...
Q-tip to keep the WD-40 away from your cabinet. (It can damage the fi nish.) Thermal Creep Your Vita spa is manufactured with energy- effi cient components and systems that capture heat generated by the equipment, then transfer that heat back to the spa water.
* - Even when the spa is shut down, some equipment will turn on if freeze protection is needed. VITA SPA DUET...
Page 27
If the problem persists, down. * The down or defective sen- contact your dealer or sensor that is service organization. plugged into May appear temporar- the Sensor ily in an over heat or “B” jack is not freeze condition working VITA SPA DUET...
Page 28
Spa will reset in 15 minutes, if the prob- lem persists contact your dealer or service organization VITA SPA DUET...
Page 29
45°F (7.2°C) status. You will not have control of the components during freeze pro- tection. If you spa is confi gured for “low” amperage your heater may not activate until the freeze condi- tion has cleared. VITA SPA DUET...
- Adjust pH; raise pH with sodium bicarbonate - Low pH product Bromine Odor/ - Low pH - Adjust pH; raise pH with sodium bicarbonate Yellow Water poduct VITA SPA DUET...
Page 31
Erratic pH Test - Sanitizer level too high - Test the pH, when the sanitizer level is Results/Unusual - Old pH indicator dye below 5 ppm pH Test Color - Replace the pH indicator dye / test strips VITA SPA DUET...
Page 32
NOTE: If your source water has a high metal or mineral content, a specialty chemical should be used to avoid staining or accumulation of deposits. These guidelines cover the most common water problems. Contact your dealer for furtherinformation regarding chemical control issues. VITA SPA DUET...
- Clogged fl oor suction or skimmer - Clean fl oor suction/skimmer and motor - Low water level - Add water to normal water level - Damaged or worn motor bearings (15cm below lip) - Contact dealer VITA SPA DUET...
Page 34
- Spa trying to heat - Check ‘Set Temperature’ in not shut off - Spa is in fi lter cycle Standard Mode - Spa is in Standard Mode - Normal. No need to change - Check mode setting VITA SPA DUET...
(pseudomonas). 8. Never use the spa while under the Ask your Authorized Vita Spa Dealer infl uence of alcohol. for guidance. 9. Consult your doctor about potential 4.
300 SERIES SYSTEM WIRING DIAGRAM Wiring Diagram For Duet 120VAC SERVICE CLASS G FUSE 30A WHT AC J25 J63 NEUTRAL (WHITE) FUSE .3A 250V HOT (BLACK) LINE 1 TORQUE RANGE FOR TB1 : 27-30 IN. LB S. GROUND WIRE J33 J34 J35...
MAAX Spas Industries Corp., reserves the right to make changes in design or material of its products at any time without incurring liability. This limited warranty applies to the fi rst retail purchaser and terminates upon any transfer of ownership. VITA SPA DUET...
Nor is any liability assumed for damages resulting from use of the information contained herein. Specifi cations subject to change without notice. Spas shown at percentage of actual size. Congratulations on your purchase of an Vita Spa from MAAX® Spas. Your Owner’s Manual provides installation, operation and maintenance instructions.