Frigidaire Laundry Center Installation Manual page 3

Laundry center
Hide thumbs Also See for Laundry Center:
Table of Contents

Advertisement

Available languages

Available languages

WARNING
Please read all instructions before using this
appliance.
Recognize safety symbols, words and
labels
Safety items throughout this manual are labeled
with a WARNING or CAUTION based on the risk
type as described below:
Defi nitions
This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey all
safety messages that follow this symbol to avoid
possible injury or death.
DANGER
DANGER indicates an imminently hazardous
situation which, if not avoided, will result in death
or serious injury.
WARNING
WARNING indicates a potentially hazardous
situation which, if not avoided, could result in
death or serious injury.
CAUTION
CAUTION indicates a potentially hazardous
situation which, if not avoided, may result in
minor or moderate injury.
IMPORTANT
IMPORTANT indicates installation, operation or
maintenance information which is important but
not hazard-related.
IMPORTANT SAFETY INSTRUCTIONS
Installation Checklist
Shipping Hardware
Foam shipping restraint (inside wash tub) removed and
stored
Shipping bolt (underneath appliance) removed and stored
Leveling
Laundry Center is level, side-to-side and front-to-back
Cabinet is setting solid on all corners
Water Supply
Rubber washers (shipped in tub) are installed in NEW inlet
hoses (shipped in tub)
HOT supply is connected to HOT inlet and COLD supply is
connected to COLD inlet
HOT and COLD water supply turned on
No leaks present at water supply connections or appliance
inlet connections - recheck in 24 hours
Drain
Stand pipe or wall drain height minimum 33"
Drain hose secured in place with cable tie (shipped in
drum)
Exhaust Venting
Free-fl owing, clear of lint buildup
4 inch (102 mm) rigid or semi-rigid ducting of minimal
length and turns
NO foil or plastic venting material
Approved vent hood exhausted to outdoors
Gas Supply (Gas Dryer)
Manual shutoff valve present in supply
All connections sealed with approved sealer and wrench
tight
Conversion kit for LP system
Gas supply turned on
No leaks present at all connections -
check with soapy water, NEVER check with fl ame
240v Electric Supply (Electric Dryer)
Approved NEMA 10-30R or 14-30R service cord with all
screws tight on terminal block
Approved strain relief installed
Terminal access cover installed before initial operation
Electrical Power
House power turned on
Laundry Center plugged in
Final Checks
Installation Instructions and Use and Care Guide
read thoroughly
Water enters drum when cycle starts with lid lowered.
Dryer door latches and drum tumbles when cycle starts.
Registration card sent in
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ffle2022mwFfle1011mw2

Table of Contents