Using Your New Projection Tv - Sony KP-43T70 Service Manual

3
Press VOLUME – to continue.
– +
VOLUME
C o n t i n u e t o
A u t o P r o g r a m ?
Y e s :
N o :
4
Press CHANNEL + to preset channels
automatically.
– +
CHANNEL
A u t o P r o g r a m
"Auto Program" appears and the
projection TV starts scanning and
presetting channels automatically. While
scanning, the received channel will be
displayed on the sub screen. When all the
receivable channels are stored, the lowest
numbered channel is displayed.

Using Your New Projection TV

Using Your New Projection TV (continued)
Watching the TV
Many TV features can be accessed directly
through the remote control. The following
chart will explain the function of some
buttons found on your remote control.
Using the White Labeled Buttons for Projection TV Operations
TV (FUNCTION) Activates the remote control for use with the projection TV.
TV POWER Turns the projection TV on and off. If a video input indication (e.g., VIDEO 1,
VIDEO 2) appears on the screen, press TV/VIDEO until a channel number
appears.
Use for direct channel selection. Press 0-9 to select a channel (for example,
-
0 9
to select channel 10, press 1 and 0). The channel will change after 2
and ENTER
seconds, or you can press ENTER for immediate selection.
CH +/– Press to scan through the channels (+ up or – down).
Speed Surf
1 Press and hold CH + or – to change the channel number rapidly.
2 Release to display the desired channel.
VOL +/– Press to adjust the volume (+ up or – down).
MUTING Press to mute the sound. "Muting" will appear on the screen and will dim
three seconds later. To restore sound, press again or press VOL +.
1 6
To perform AUTO SET UP again
[ C H + ]
[ C H – ] SET UP MENU
Press SET UP inside the drop-down panel on
the projection TV and perform steps 2-4
above.
Press SET UP again to exit.
Adjusting the Convergence
Automatically (FLASH FOCUS)
The projection tube image appears on the
screen in three layers (red, green and blue). If
they do not converge, the color is poor and
the picture blurs.
Before you use your projection TV, be sure to
adjust the convergence.
The FLASH FOCUS feature allows you to
adjust the convergence automatically.
z
Tips
• It is recommended to perform FLASH FOCUS about
30 minutes after the projection TV is first turned on.
• You can also perform FLASH FOCUS using the Set
Up menu on page 31.
TV/VIDEO
FLASH FOCUS
Press FLASH FOCUS.
The cross pattern appears and FLASH
FOCUS begins to work. The adjustment is
completed when the cross pattern becomes
white.
Note:
• FLASH FOCUS is canceled if you
perform any other function while FLASH
FOCUS is working.
PICTURE MODE
Press PICTURE MODE repeatedly to directly
choose one of five different video modes that
best suits the program you are watching.
Vivid: Select for enhanced picture contrast and
Standard: Select to display a standard
Movie: Select to display a finely detailed
Personal 1, Personal 2: Select to customize
When you select "Movie," "Personal 1" and
"Personal 2," you can also perform the "Picture
Adjustment" (such as "Brightness," "Color," etc.)
to suit your taste. For details, see "Mode" on
page 22.
– 16 –
FLASH FOCUS
sharpness.
picture for normal viewing environments.
picture for low light environments.
the "Picture Adjustment" of the Video menu
according to your personal preference.
1 5