Using Your New Projection Tv; Getting Started; Step 1: Connect The Antenna - Sony KP-ER43M31 Service Manual

Using Your New Projection TV

Getting Started

Step 1
Connect the antenna
If you wish to connect a VCR, see the "Connecting a VCR" diagram below.
or
Antenna cable (not supplied)
Antenna cable (not supplied)
: Signal flow
Connecting a VCR
To play a video tape, press t (see page 14).
Antenna cable (not supplied)
To antenna
output
AUDIO VIDEO
R L
VIDEO IN
VIDEO OUT
To video and
audio outputs
: Signal flow
IEC connector
(not supplied)
CAUTION
Do not connect the power cord until all other connections are
complete; otherwise, a minimal current leakage through the antenna
and/or other terminals to the ground could occur.
VCR
S video cable
(not supplied)
To S video
output
Audio/Video cable
(not supplied)
Rear of
projection TV
To 8 (antenna)
Rear of
projection TV
To
(S video input)
1 2 3
To t 1, 2 or 3 (video input)
(yellow)
-L (MONO) (white)
-R (red)
Using Your New Projection TV
C –
Y
3
C /
B
B-Y
#
C /
R
R-Y
30W MAX 16
L L
R R
continued
5