Extra Information; Setting Your Sky+ Remote Control To Operate Your Tv - Pace Sky plus User Manual

Extra information

❖ Setting your Sky+ remote control to
operate your TV
Your Sky+ remote control can operate both your Sky+ set top box
and your TV.
Your Sky+ remote control should have been set up to work with your
TV when your Sky+ set top box was installed.
If your Sky+ remote control is not correctly operating your TV,
complete the following steps.
Before you start, look up the four-digit code for your brand of TV in
this list.
Brand Code
Akai 0098
Alba 0043
Amstrad 0063
Bush 0157
Decca 0244
Ferguson 0293
Fidelity 0294
Finlandia 0296
Goodmans 0335
If your brand of TV is not shown here, refer to Remote control setup
codes on page 78.
1. Turn your TV on.
2. Press tv on your Sky+ remote control.
3. Hold down select and the red key together for about two
seconds, until the red light on your Sky+ remote control blinks
twice.
4. Press tv on your Sky+ remote control again.
5. Key in the four-digit code for your brand of TV. The light on
your Sky+ remote control should blink twice.
If the light blinks once only, recheck the code for your brand of TV and
start again at Step 1.
58
Brand Code
Granada 0340
Grundig 0345
Hinari 0365
Hitachi 0145
JVC 0053
Matsui 0477
Mitsubishi 0150
NEI 0514
Nokia 0536
Brand Code
Panasonic 0051
Philips 0081
Saisho 0649
Samsung 0060
Sanyo 0159
Sharp 0093
Sony 0000
Tatung 0049
Toshiba 0156
Sky+ User's Guide