Setting Your Sky Active Keypad To Operate Your Sky - Pace Sky plus User Manual

6. Press the standby key (
If your TV switches off, press select. The light on your Sky+
remote control should blink twice.
If your TV does not switch off, press tv, then press the standby
key (
until your TV turns off, then press select.
If the light on your Sky+ remote control blinks three times, it has
checked all the possible settings for the code you used. Check that
you have the correct four-digit code and start again at Step 1.
7. Turn your TV back on again and then press tv guide.
If you see the TV Guide screen, the remote control setup
process is complete.
If you do not see the TV Guide screen, you must now complete the
following steps.
8. Press tv on your Sky+ remote control.
9. Hold down select and the green key at the same time for
about two seconds, until the red light on your Sky+ remote
control blinks twice.
10. Key in the number of the channel on your TV that you use for
watching satellite TV.
11. Press select on your Sky+ remote control. The red light should
blink twice. The remote control setup process is now complete.
If after trying this, you still have problems, call Sky+ Customer Service.
To find the Sky+ Customer Service number, select the Telephone
Numbers option from the Services screen.
❖ Setting your Sky Active keypad to operate
your Sky+
Your Sky Active keypad can be set up to operate your Sky+ set top box
for functions other than recording and playback. To set up your keypad:
1. Turn your TV on.
2. Press the TV/sat button on your keypad.
3. Hold down select and the blue key at the same time for about
two seconds, until the red light on your keypad blinks twice.
4. Press 2 then select.
5. Press Sky on your keypad.
Sky+ User's Guide
) on your Sky+ remote control.
). Repeat this action (press tv, then the standby key)
59