Table of Contents
Advertisement
REQUIRED CONNECTIONS
CAUTION: Protect the unit against lightning. If a portion of a cable is installed
outside of a building, the entire cable is vulnerable to lightning.
Therefore, install surge protection devices on all vulnerable cables.
Cameras In
Connect the video output of each camera or other composite video source to its
corresponding Camera In connector (the left of each pair of BNC connectors). To use
the passive loop through feature, see
Monitor
The monitor displays live and recorded cameras, as well as system configuration and
status information.
To connect the monitor:
1. Disconnect both ribbon cables from connectors
Figure 5 — Rear Panel Connectors
2. Connect the VGA cable from an SVGA monitor to the Monitor connector.
3. Reconnect both ribbon cables to connectors
Power Setting
CAUTION: Before connecting power, set the voltage switch to the correct
voltage ("115" or "230").
Switch the power supply to the correct input voltage setting: 115 or 230 volts.
Power In
CAUTION: You may want to install power line conditioning equipment to protect
the unit against severe power fluctuations.
CAUTION: Do not apply power until you have connected all optional items.
Connect the power cable to the unit.
Mouse
Connect the mouse (or other pointing device) to the Mouse connector.
Installation
Intellex DV16000 Digital Video Management System
Cameras Out
on page 16.
18
and
on page 12).
18
and
16
16
on the rear panel (see
on the rear panel.
15
Advertisement
Table of Contents
