Parts Introduction; Control Panel - Drive; How To Operate Your Powerchair - Drive Medical Sunfire Plus EC Owner's Handbook Manual

3. PARTS INTRODUCTION

The parts description below applies to rear wheel
drive powerchairs:
SEAT
ROTATE
LEVER
SHROUD
REAR
(DRIVE)
WHEEL
FRONT
(CASTOR)
WHEEL
The parts description below applied to mid wheel
drive powerchairs:
HEAD REST
SEAT BACK
REST
CONT-
ROLLER
ARM REST
SEAT BASE
SEAT
ROTATE
LEVER
FOOT PLATE
FRONT
(CASTOR)
WHEEL
Drive Powerchair Range
HEAD REST
SEAT BACK
REST
ARM REST
CONTROLLER
SEAT BASE
FOOT PLATE
REAR
MID (DRIVE)
(ANTI TIP)
WHEEL
WHEEL
Page 4
4. PARTS INTRODUCTION
Control Panel
Control Panel
Joystick
(see previous
Joystick Control Panel shown above

HOW TO OPERATE YOUR POWERCHAIR

1. Joystick. The primary function of the joystick is to
control the speed and direction of the
wheelchair. The further you push the joystick
from the center position the faster the
wheelchair will move. When you release the
joystick the brakes are automatically applied.
2. On / Off button. The on/off button applies
power to the control system electronics, which in
turn supply power to the wheelchair's motors. Do
not use the on/off button to stop the wheelchair
unless there is an emergency. (If you do, you may
shorten the life of the wheelchair drive
components). The battery gauge shows you that
the wheelchair is switched on. It also indicates
the operating status of the wheelchair.
3. Increase Speed / Profile. Press this button to
increase the maximum speed of the wheelchair.
Battery Gauge
On / Off Button
Horn
Speed / Profile Indicator
Increase Speed / Profile
Decrease Speed / Profile
diagram)
Charger and
Programmer socket
Z20945 (Rev C)