Table of Contents
Advertisement
The 11050 Platform
Power supply LEDs
The power supply LEDs indicate the operating state of the power supplies.
Power 1 state
green solid
yellow solid
off/none
LED alert conditions
When there is an alert condition on the unit, the Alarm LED behaves in a specific manner.
Note: The Alarm LED might continue to display until alerts are cleared using the LCD panel.
Action
System situation
Emergency
Alert or Critical
Error
Defining custom alerts
The
/etc/alertd/alert.conf
alerts that cause the indicators to change. The
alerts, and the
Note: You should edit only the
1. Open a command prompt on the system.
2. Change to the
cd /config
3. Using a text editor, such as vi or Pico, open the
4. Add the following lines to the end of the file:
alert BIGIP_MCPD_MCPDERR_POOL_MEMBER_MON_DOWN "Pool member (.*?):(.*?) monitor
status down."
{
snmptrap OID=".1.3.6.1.4.1.3375.2.4.0.10";
lcdwarn description="Node down" priority="1"
}
alert BIGIP_MCPD_MCPDERR_NODE_ADDRESS_MON_DOWN "Node (.*?) monitor status
14
Power 2 state
green solid
yellow solid
off/none
and the
/config/user_alert.conf
/config/user_alert.conf
/config/user_alert.conf
directory.
/config
Description
Power supply is present and
operating properly.
Power supply is present, but not
operating properly. Also indicates
when the system in is power
standby mode.
No power supply present.
Description
Alarm LED behavior
Red blinking
Red solid
Yellow blinking
files on the BIG-IP system define
/etc/alertd/alert.conf
file defines custom settings.
file.
/config/user_alert.conf
file defines standard system
file.
Advertisement
Table of Contents
