Table of Contents
Advertisement
Control Modes
There are 4 modes:
One TWIST-5LED
(Built-in
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the TWIST-5LED is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 15 for more information about the built-in programs.
One TWIST-5LED (Sound-control)
1.Plug the end of the electric mains power cord into a proper electric power supply socket.
2.
Turn on the music. If the device is set to sound-control, then the TWIST-5LED will react to the beat of the
music.
Please see page 15 for more information about the sound-control
Multiple TWIST-5LEDs
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the TWIST-5LED.
The pins:
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 15 (Built-in Programs,
or
Music control). This means on the master device you can set your desired operation Mode
and all slave devices will react the same as the master device.
• Stand-alone (built-in programs)
• Sound-controlled
• Master/Slave
• DMX512 (13 Channels ADVANCED or 8 channel BASIC)
Programs)
(Master/Slave control)
1.
Earth
2.
Signal -
3.
Signal +
Multiple TWIST-5LEDs
(Master/Slave control)
8
options.
Fig. 3
Hide quick links:
Advertisement
Table of Contents
