Table of Contents
Advertisement
Control Panel
A. LCD Display
B. MODE/ESC button
C. Up Button
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the TWIST-5LED will respond to the controller.
Please note when you use the controller, the unit has 13 channels.
When using multiple TWIST-5LEDs, make sure you set the DMX addresses right.
Therefore, the DMX address of the first TWIST-5LED should be 1(001); the DMX address of the second TWIST-5LED
should be 1+13=14 (014); the DMX address of the third TWIST-5LED should be 14+13=27 (027), etc.
Please, be sure that you don't have any overlapping channels in order to control each TWIST-5LED
correctly.
If two or more TWIST-5LEDs are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under "Addressing'.
Controlling:
After having addressed all TWIST-5LED fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the TWIST-5LED will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX-input, the "LED " on the control panel will not flash.
The problem may be:
- The XLR cable from the controller is not connected with the input of the TWIST-5LED.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It's necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
D. Down Button
E. ENTER Button
11
Fig. 5
Hide quick links:
Advertisement
Table of Contents
