Putting Batteries - Hitachi CP-SX1350 P5SX+ Service Manual

6-2 Before replacing the LCD/PRISM assembly
You should not replace separately the parts of the liquid crystal panel of LCD/Lens prism because it works
properly only when used together. Therefore, regarding these parts, you can either replace part, LCD/
PRISM assembly, or send the whole unit LCD/PRISM assembly back to HITACHI, where we will replace the
malfunctioning part, recondition the device and send it back to you. Note that you can also replace the LCD/
LENS PRISM assembly, which consists of LCD/PRISM assembly and LENS assembly.
DISTRIBUTOR
NOTE : When it is hard to screw the LCD/Lens Prism assembly on the bottom case, extend elevator feet to do easily.

6-3 Putting batteries

• About the battery
• Keep a battery away from children and pets.
• Use only the battery specifi ed: two AA batteries.
• Do not mix new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading the battery (as indicated in the
remote control).
• Dispose of batteries in accord with environmental laws.
1. Remove the battery cover.
Slide back and remove the battery cover in the direction of the arrow.
2. Insert the batteries.
Align and insert the two AA batteries according to their plus minus
terminals (as indicated in the remote control).
3. Close the battery cover.
Replace the battery cover in the direction of the arrow and snap it back
into place.
CP-SX1350(P5SX+)
Do not disassemble the unit
because replacement of separate
parts is not possible.
Return
CAUTION
19
HITACHI
Replacement of G Panel Reconditioning
G Panel