Before Replacing the LCD / Lens Prism
You should not replace separately the parts of the liquid crystal LCD / Lens Prism because it works properly
only when used together. Therefore, regarding these parts, you can either replace part, LCD / Lens Prism
assembly, or send the whole unit LCD / Lens Prism assembly back to HITACHI, where we will replace the
malfunctioning part, recondition the device and send it back to you. In that case please contact our distributor.
DISTRIBUTOR
Putting batteries into the remote control unit
CAUTION Precautions to observe in regards to the batteries
Always handle the batteries with care and use them only as directed. Improper use may result in
battery cracking or leakage, which could result in fire, injury and/or pollution of the surrounding environment.
• Keep the battery away from children and pets.
• Be sure to use only the batteries specified for use with the remote control. Do not mix new batteries with used ones.
• When inserting batteries, verify that the plus and minus terminals are aligned correctly (as indicated in the remote control).
• When you dispose the battery, you should obey the law in the relative area or country.
Remove the battery cover
1
Slide back and remove the battery cover in the direction of the
arrow.
Insert the batteries
2
Align and insert the two AA batteries (that came with the
projector) according to their plus and minus terminals (as
indicated in the remote control).
Close the battery cover
3
Replace the battery cover in the direction of the arrow and
snap it back into place.
CP-X880/CP-X885
Do not disassemble the unit
because replacement of separate
parts is not possible.
Return
19
HITACHI
Replacement of G Panel
G Panel
Reconditioning