Kenmore 758.154120 Operator's Manual page 10

Using Your Humidifier (cont'd.)
Humidistat
The humidistat located on the power cord
senses the percentage of humidity in the
air. It causes the humidifier to cycle on
and off to maintain the selected humidity
SET point. The fan will turn on if the
ROOM reading falls 3% below the SET
point and will continue to run the
humidifier until a reading of 1% above the
SET point is achieved. The fan will turn
off until the ROOM reading falls 3%
below the SET point again.
Control Lock Out
This feature allows the controls to be
locked to avoid unwanted tampering.
Activation Procedure
After the desired humidifier settings have
been set, press and hold the power
button down for 5 seconds. The key icon
will be displayed indicating the
control lock is active. If any buttons on
the control are pressed while lock out is
active, CL will be displayed on the LCD
screen for 3 seconds and then return to
normal and standard LCD display screen
and humidifier operation resumes.
Deactivation Procedure
To deactivate, press and hold the power
button for 5 seconds. The key icon
will disappear. Humidifier settings may
now be changed as desired.
NOTE: Be sure humidistat, which is
located on power cord, is free from
obstruction and away from any hot air
source.
@ 1
10