Using Humidifier; Power/Refill Light; Cheek Filter Indicator - Kenmore 758.154120 Operator's Manual

Using Your Humidifier
Power/Refill Light
For maximum run time both the bottle
and the base should be filled. When both
the bottle and the base are empty the red
POWER/REFILL light will flash, informing
additional water is required. Also at this
time the unit will automatically switch into
DRY OUT and continue to run on
WHISPER speed for a 2 hour period. The
message DRY OUT will appear on the
digital display and the fan speed will
switch to WHISPER speed.
Power/Refill
Light
NOTE: During this time the room
humidity level will continue to be
monitored and the humidifier will cycle
the fan on and off until the filter is
completely dry. The fan will shut off
leaving you with a dry humidifier that is
less prone to mold and mildew growth.
If DRY OUT is not desired, refill the
humidifier with water.
NOTE: Once the dry out cycle is
complete, the fan will shut off and the
POWER/REFILL light will stay
illuminated. The humidifier will
automatically start again when it is
refilled.
Dry Out\
\
Flashing
Power/Refill Light
Cheek Filter indicator
The ability of any humidifier to efficiently
supply humidity output relies heavily on the
condition of the filter. As the filter loads with
impurities it gradually loses its wicking
capability. When this happens, moisture
output is reduced and the humidifier has to
work longer to satisfy the selected setting.
This humidifier has a check filter reminder
timed to appear after 720 hours of
operation. When the CK FILTER message
is displayed, disconnect the power cord
and check the condition of the filter. If a
build-up of deposits or severe discoloration
is evident replace the filter to restore
maximum efficiency. The CK FILTER
message is reset when the humidifier is
plugged back in.
Check Filter\
\
\