Maintenance & Care - Bissell Bolt User Manual

Maintenance & Care
Disposal of batteries
If your Bolt Cordless Hand Vacuum is to be
disposed of, the batteries should be removed
and disposed of properly.
1. IMPORTANT: Unplug charger.
2. Remove dirt cup from handle.
3. Remove (2) Phillips head screws and remove
the lens from the hand vacuum.
4. Remove (2) Phillips head screws from the
hand vacuum cover.
5. Lift off the hand vacuum cover.
6. Take out push rod.
7. Remove (5) Phillips head screws from the
side of the hand vacuum.
8. Remove the entire battery assembly from
the cover.
9. Cut wires from the PCB and wrap the wire
ends with insulation tape.
10. Keep Battery Pack together – DO NOT
separate individual batteries. For specific
disposal instructions of batteries, please
contact RBRC (Rechargeable Battery
Recycling Corporation) 1-800-822-8837 or
visit www.rbrc.com.
11. Discard remainder of product
CAUTION: Disconnecting the battery will
destroy the appliance and void the warranty.
www.BISSELL.com
8
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
7.
5 screws
WARNING
This product contains Nickel
Metal Hydride (Ni-MH)
rechargeable batteries.
According to Federal and
State regulations, removal
and proper disposal of
Ni-MH batteries is required.
For removal of the batteries
in your Bolt see instructions on this page.
TM