Important Safety Instructions - Porter-Cable US58 Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

W ARNING: When using pneumatic tools, basic safety precautions should
always be followed to reduce the risk of personal injury, i n c l u d i n g t h e f o l l o w i n g :
There are certain applications for which this tool was designed. Porter-Cable
strongly recommends that this tool NOT be modified and/or used for any
application other than for which it was designed. If you have any questions
r e l a t i v e t o i ts application DO NOT use the tool until you have written Porter-
Cable and we have advised you.
1 . USE SAFETY GLASSES. To prevent eye
i n j u r i e s , t h e t o o l o p e r a t o r a n d a l l p e r s o n s i n t h e
work area must wear safety glasses with
permanently attached, rigid, plastic side
s h i e l d s . These safety glasses must conform to
ANSI Z87.1 requirements (approved glasses
have Z87 printed or stamped on them).Fig. 1.
2 . WEAR EAR PROTECTION to safeguard
against possible hearing loss. Fig. 1.
3 . USE CLEAN,
compressed air at 60 to 100 PSI. Fig. 2.
4 . DO NOT CONNECT TO O L TO pressure
which potentially exceeds 200 PSI (13.7
BAR).
5 . O N LY USE AIR HOSE THAT IS RATED
for a minimum working pressure of 150 PSI
or 150% of the maximum system pressure,
which ever is greater.
6 . NEVER USE
DIOXIDE, combustible gases or any other
bottled gas as a power source for this tool:
explosion and serious personal injury could
r e s u l t . F i g . 3 .
7 . CONNECT
H O S E with a coupling that removes all
pressure from the tool when the coupling is
disconnected. Fig. 4.
READ AND FOLLOW ALL INSTRUCTIONS.
DRY, REGULAT E D
OXYGEN,
TO O L TO AIR SUPPLY
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
P. O. Box 2468
Jackson, TN 38302-2468
Fig. 1
Fig. 2
Fig. 3
CARBON
Fig. 4
2 2