Dubbing Still Images Recorded On A Tape To A Memory Card (Gr-Dvl720/Dvl520 Only) - JVC GR-DVL520 Instructions Manual

52
EN
SNAPSHOT Button
Power Switch
Lock Button
Display
COPY – OF F
ON
Play/Pause Button (4/6)
VIDEO/MEMORY Switch
(Open the LCD monitor
to access this switch.)
Menu Screen
SP SP 4 4 6 6
MENU/BRIGHT
Wheel
Dubbing Still Images Recorded On A Tape
To A Memory Card
Still images can be dubbed from a tape to a memory
card.
1
Load a memory card (
( pg. 12).
2
Set the VIDEO/MEMORY Switch to "VIDEO",
then set the Power Switch to "PLAY" while pressing
down the Lock Button.
3
Press the MENU/BRIGHT wheel in. The Menu
Screen appears. Rotate it to select "
press it. The VIDEO Menu appears.
4
Rotate the MENU/BRIGHT wheel to select
" COPY" and press it. The Sub Menu
appears. Rotate it to select "ON" and press it.
Selection is complete.
5
Rotate the MENU/BRIGHT wheel to select "
RETURN" and press it twice. The normal playback
screen reappears.
6
To select a video image to be dubbed, start
playback by pressing 4/6. At the moment you find
the image you wish to dub, press it again to engage
Still Playback.
7
To start dubbing, press SNAPSHOT. The selected
image is stored on the memory card.
• " " blinks during dubbing.
NOTES:
If SNAPSHOT is pressed in step 7 when a memory
card is not loaded, the message "COPYING FAILED" is
displayed.
If an image recorded on the tape using the WIDE mode
( pg. 46) is dubbed to a memory card, the WIDE
mode identifying signal is not dubbed with it.
To use Playback Special Effects with a video image you
wish to dub, perform up to step 7 using the remote
control (provided with GR-DVL720 only) (
Images are dubbed in 640 x 480 pixels.
DUBBING
(cont.)
(GR-DVL720/DVL520 only)
pg. 14) and cassette
VIDEO" and
pg. 56).