Energypak And Charger; Handlebar And Stem; Energypak And Charger Operation - Giant Twist Freedom DX Owner's Manual

Hide thumbs Also See for Twist Freedom DX:
Table of Contents

Advertisement

B. ENERGYPAK AND CHARGER
3
1
1. EnergyPak (battery)
2. Handle
3. EnergyPak Lock with Key
4. Charging Socket
C. handlebar and stem
2
1
1. Handlebar
2. RideControl Command Center
(left hand control)
3. Handlebar Stem
2
4
6
5
5. Charger
6. Charger Plug
7. Power Source Plug
6
3
4
5
4. Power Control Switch
(on models with two EnergyPaks)
5. Gear Shifter
6. Gear Indicator (may look different
depending on model of bicycle)
5

2. ENERGYPAK AND CHARGER OPERATION

7
THE ENERGYPAK(S) MUST BE FULLY CHARGED BEFORE THE FIRST RIDE OR IF
THE BIKE HAS NOT BEEN RIDDEN FOR OVER A MONTH!!
• Charge the EnergyPak in a room with a temperature between 0 - 37 degrees C.
• If you notice a strange smell or smoke, stop the charging procedure immediately! Take the
EnergyPak and charger to your Authorized Giant Dealer for service or replacement.
• DO NOT CHARGE THE ENERGYPAK FOR LONGER THAN 24 HOURS!! This could seriously
reduce the life of the EnergyPak.
• NEVER CHARGE AN ENERGYPAK WHILE IT'S INSTALLED AND CONNECTED TO THE
HYBRID BICYCLE!!
A. Normal Charging
EnergyPak Lithium-Ion battery: 244-LI9AH-02V
On a Hybrid Cycling
step 1
Technology bicycle with two
EnergyPaks, turn the Power
Control Switch (on right side
of the handlebar) to the "OFF"
position. On a bicycle with one
EnergyPak, make sure the
"ON/OFF" button is pushed
to "OFF" on the RideControl
Command Center (on the left
side of the handlebar) and that
none of the LED's on the unit
are illuminated.
Follow steps A and B to
step 2
open the Rear Pannier bag.
Disregard these steps if
your bicycle does not have
the Rear Pannier bag.
Turn the EnergyPak lock key to
step 3
the "OPEN" position and at the
same time push the top of the
EnergyPak outward to 45 degrees.
caution
Power Control Switch -
RideControl Command Center -
Two EnergyPak Hybrid bicycle
Single EnergyPak Hybrid bicycle
Turn to "Off" to remove
Push "ON/OFF" button to "OFF"
EnergyPaks
to remove EnergyPak
Step A
Step B
Pull
Key
6
Pull up
Push

Advertisement

Table of Contents
loading

Table of Contents