Pour toute question ou tout commentaire, nous contacter.
INSTRUCTION MANUAL
GUIDE DE'UTILISATION
MANUAL DE INSTRUCCIONES
Propane Portable Radiant Construction Heater DXH45LP
Fournaise radiante et portable au propane pour la construction DXH45LP
Calentador radiante portátil a propano para la construcción DXH45LP
READ INSTRUCTIONS CAREFULLY: Read
and follow all instructions. Place instructions
in a safe place for future reference. Do
not allow anyone who has not read these
instructions to assemble, adjust or operate
the heater.
If you have questions or comments, contact us.
855-805-5745 • www.dewalt.com
VEUILLEZ LIRE ATTENTIVEMENT LES INSTRUCTIONS :
Lisez et observez toutes les instructions. Conservez
ces instructions dans un endroit sécuritaire pour vous
y référer ultérieurement. Interdisez à quiconque n'ayant
pas lu les présentes instructions d'assembler, d'ajuster
ou de faire fonctionner la fournaise.
Si tiene dudas o comentarious, contéctenos.
INSTRUCTIVO DE OPERACION, CENTROS DE SERVICIO Y POLIZA
DE GARANTIA, ADVERTENCIA: LEASE ESTE INSTRUCTIVO ANTES
DE USAR EL PRODUCTO.
4/13 70762 Rev13A
LEA CUIDADOSAMENTE LAS INSTRUCCIONES:
Lea y siga todas las instrucciones. Conserve
estas instrucciones en un lugar seguro para futura
referencia. No permita que nadie que no haya
leído estas instrucciones arme, ajuste o use el
calentador.
a
Need help?
Do you have a question about the DXH45LP and is the answer not in the manual?
Questions and answers
My heater turns off after 5 minutes of being lit
The DeWalt DXH45LP heater may turn off after 5 minutes due to a gas leak, improper gas supply, or a faulty safety valve. The manual advises checking for gas leaks using a soap and water solution, ensuring the correct fuel type is used, and listening for the closure of the safety valve. If a leak is detected, the gas supply should be shut off immediately and repairs should be made after waiting at least five minutes. Additionally, the hose and regulator assembly should be inspected for wear or damage.
This answer is automatically generated
When it gets hot it blows flames out the top. What do I need to replace
If the DeWalt DXH45LP blows flames out the top when it gets hot, possible parts that may need to be replaced include:
- Thermocouple (if defective)
- Control unit (if defective)
- Tip-over switch (if defective)
Also, ensure the thermocouple is correctly positioned between the reverberator and grid, and that all wires are securely connected.
This answer is automatically generated