JVC GR-DVF20 Instructions Manual page 61

SYMPTOM
25. The indicators and
messages do not appear on
screen.
26. The indicators do not
appear.
27. Images on the LCD
monitor appear dark or
whitish.
28. The rear of the LCD
monitor is hot.
29. The indicators and the
image color on the LCD
monitor are not clear.
30. Images on the LCD
monitor are jittery.
31. The LCD monitor, the
viewfinder and the lens
have become dirty
(ex. fingerprints).
32. The LCD monitor or
viewfinder indications
blink.
33. Colored bright spots
appear all over the LCD
monitor or the viewfinder.
POSSIBLE CAUSES
25. •"ON SCREEN" is set to
"OFF" in the Date/Time
Menu.
26. •You have made the
indicators disappear.
27. •In places subject to low
temperature, images become
dark due to the characteristics
of the LCD monitor. When
this happens, the displayed
colors differ from those that
are actually recorded. This is
not a defect of the camcorder.
•When the LCD monitor's
fluorescent light reaches the
end of its service life,
images on the LCD monitor
become dark. Consult your
nearest JVC dealer.
28. •The light used to illuminate
the LCD monitor causes it to
become hot.
29. •This may occur when the
surface or the edge of the
LCD monitor is pressed.
30. •The speaker volume is too
great.
31.
————
32. •Certain Fade/Wipe effects,
certain modes of Program AE
with special effects, Picture
Stabilizer and other functions
that cannot be used together
are selected at the same time.
33. •The LCD monitor or the
viewfinder is made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD
monitor or the viewfinder.
These spots are not
recorded on the tape. This is
not due to any defect of the
unit. (Effective dots: more
than 99.99 %)
CORRECTIVE ACTION
25. •Set "ON SCREEN" to "ON"
in the Date/Time Menu
( pg. 23).
•Press DISPLAY for longer
than 1 second to make the
indicators appear (
26. •Press DISPLAY for longer
than 1 second to make the
indicators appear (
27. •Adjust the brightness and
angle of the LCD monitor
( pg. 19).
28. •Close the LCD monitor to
turn it off or set the Power
Switch to "OFF", and let the
unit cool down.
29.
————
30. •Turn the speaker volume
down ( pg. 40).
31. •Wipe them gently with soft
cloth. Wiping strongly can
cause damage.
32. •Re-read the sections
covering Fade/Wipe effects,
Program AE with special
effects and Picture Stabilizer
( pg. 20, 29, 30, 32, 33).
33.
————
CONTINUED ON NEXT PAGE
61
EN
pg. 17).
pg. 17).