JVC GR-DVA1 Instructions Manual page 26

26
EN
Date/Time Menu Explanations
ON SCREEN
DISPLAY
DATE/TIME
System Menu Explanations
PHOTO MODE
TALLY
WIND CUT
SOUND MODE
ID NUMBER
DEMO. MODE
: Factory-preset
Keeps the camcorder's display from appearing on the connected TV
OFF
screen.
Makes the camcorder's display appear on screen when the
ON
camcorder is connected to a TV.
Makes the date/time settings appear in the camcorder (
ON
Keeps the date/time settings from appearing in the camcorder.
OFF
Allows you to set the current date and time (
Allows you to set the parameters for "FULL", "FRAME", "PIN-UP", "MULTI 4" and
"MULTI 9" recording (
The tally lamp comes on to signal the start of recording.
ON
The tally lamp remains off at all times.
OFF
Disengages the function which cuts down on noise created by wind.
OFF
Helps cut down on noise created by wind.
ON
•"
•The quality of the sound will change. This is normal.
32 kHz Enables recording of stereo sound on four separate channels, and is
recommended for use when performing audio dubbing with another
digital camcorder.
Enables recording of stereo sound on two separate channels.
48 kHz
This number is necessary when connecting the camcorder to a device such as a
computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting
is 07.
Automatic demonstration will not take place.
OFF
Demonstrates certain functions such as Program AE with special
ON
effects, etc., and can be used to confirm how these functions operate.
When "DEMO. MODE" is set to "ON" and the Recording Menu is
closed, demonstration starts.
NOTES:
If a tape is in the camcorder, the demonstration cannot be turned
on.
By turning off the camcorder, "DEMO. MODE" is set to "OFF"
automatically.
RECORDING
pg. 22).
" appears.
Advanced Features (cont.)
pg. 11).
pg. 11).