JVC GR-DV3000A Instructions Manual page 76

76
EN
SYMPTOM
*
During R.A.Edit, the Picture
Wipe and Dissolve
functions do not work.
(
Scene transition does not
go as expected.
)
White Balance cannot be
activated.
q
When shooting a subject
illuminated by bright light,
vertical lines appear.
w
When the screen is under
direct sunlight during
shooting, the screen
becomes red or black for an
instant.
e
During recording, the date/
time does not appear.
r
Files stored on the memory
card cannot be deleted.
POSSIBLE CAUSES
• The last selected editing scene is
ending.
• At the end of the last selected
scene for editing, the Power switch
was set to "OFF".
• The power is off.
• When using "Picture Wipe/Dissolve"
( pg. 68), there is a delay of a
fraction of a second between the
previous record stop-point and the
Dissolve start-point. This is normal,
but this slight delay becomes
especially noticeable when
shooting fast-moving subject or
during rapid panning.
• The Sepia or Monotone mode is
activated.
• This is a result of exceedingly high
contrast, and is not a malfunction.
• This is not a malfunction.
• "DATE/TIME" is set to "OFF" in the
Menu Screen.
• Interface Shooting is performed.
• Files stored on the memory card
are protected.
TROUBLESHOOTING
CORRECTIVE ACTION
• Select Picture Wipe or Dissolve
before beginning editing. The
effects are then automatically
activated ( pg. 68).
• Do not turn off the camcorder's
power after setting Edit-In and Edit-
Out points, as they will all be
erased ( pg. 68).
• The camcorder automatically shuts
off after 5 minutes have elapsed in
the Pause mode. Make sure you
continue operations within 5
minutes after engaging Pause
mode ( pg. 68).
————
• Turn off Sepia or Monotone before
setting White Balance (
41).
————
————
• Set "DATE/TIME" to "ON" in the
Menu Screen (
• During Interface Shooting, the
date/time does not appear
( pg. 19).
• Remove protection from the files
stored on the memory card and
delete them ( pg. 49, 50).
(cont.)
pg. 39,
pg. 31).