JVC GR-DV3000A Instructions Manual page 30

30
EN
Menu Screen Explanations (cont.)
WIDE OFF
MODE
CINEMA
SQUEEZE
D.WIDE
WIND OFF
CUT
ON
BEEP
OFF
BEEP
MELODY
TALLY OFF
ON
DEMO OFF
MODE
ON
NOTES:
The " MANUAL" settings are effective only when the Power Switch is set to "
" SYSTEM" functions which are set when the Power Switch is set to "
is set to " " ( pg. 32).
USING MENUS FOR DETAILED ADJUSTMENT
Records with no change in the screen ratio. For playback on a TV with a
normal screen ratio.
Inserts black bands at the top and bottom of the screen. During playback on
wide-screen TVs, the black bands at the top and bottom of the screen are cut
and the screen ratio becomes 16:9.
to your wide-screen TV's instruction manual. During playback/recording on 4:3
TVs/LCD monitor/viewfinder, black bands are inserted at the top and bottom of
the screen and the image appears like a letterboxed 16:9 movie.
• "CINEMA" mode is effective only when the VIDEO/MEMORY Switch is set to
"VIDEO" ( pg. 14).
For playback on TVs with an aspect ratio of 16:9. Naturally expands the image
to fit the screen without distortion.
your wide-screen TV's instruction manual. During playback/recording on 4:3
TVs/LCD monitor/viewfinder, the image is elongated vertically.
• "SQUEEZE" mode is effective only when the VIDEO/MEMORY Switch is set
to "VIDEO" ( pg. 14).
" " appears. The zoom range is extended beyond the maximum optical zoom
wide angle range. This mode's wide angle setting is equivalent to using a 0.7X
wide conversion lens. Zooming is possible from 0.7X to 10X. This mode is
suitable for shooting in a small room.
• "D.WIDE" mode is effective only when the VIDEO/MEMORY Switch is set to
"VIDEO" ( pg. 14).
Disengages the function which cuts down on noise created by wind.
Helps cut down on noise created by wind. "
sound will change. This is normal.
Even though not heard while shooting, shutter sound is recorded on the tape.
The beep sounds when the power is turned on or off, and at the beginning and end
of recording. Also to activate the shutter sound effect (
Instead of a beep, a melody sounds when any operation is performed. It also
activates the shutter sound effect (
The tally lamp remains off at all times.
The tally lamp comes on to signal the start of recording.
Automatic demonstration will not take place.
Demonstrates certain functions such as Programme AE with special effects,
etc., and can be used to confirm how these functions operate.
Demonstration starts in the following cases:
• When the Menu Screen is closed after "DEMO MODE" is turned "ON".
• With "DEMO MODE" set to "ON", if there is no operation for about 3 minutes
after the Power Switch is set to "
Performing any operation during the demonstration stops the demonstration
temporarily. If no operation is performed for more than 3 minutes after that, the
demonstration will resume.
NOTES:
If a tape is in the camcorder, the demonstration cannot be turned on.
"DEMO MODE" remains "ON" even if the camcorder power is turned off.
If "DEMO MODE" remains "ON", some functions will not be available. After
viewing demo, set to "OFF".
appears. When using this mode, refer
appears. When using this mode, refer to
" appears. The quality of the
pg. 20, 21).
pg. 20, 21).
" or " ".
".
" are also applied when the Power Switch
(cont.)
: Factory-preset