Motion Detection - Samsung SHC-721N Instruction Manual

Operating Your Camera
S-ATW(Special Auto Tracking White balance): When color temperature is
1800~6000K, specially in sodium lamp, select this mode. (EX. sodium lamp, inside the
tunnel)
H-ATW(High Auto Tracking White balance): If there are bright and dark parts
on the screen at the same time, White Balance operates for bright part.
L-ATW(Low Auto Tracking White balance): If there are bright and dark parts
on the screen at the same time, White Balance operates for dark part.
AWC(Auto White balance Control): The white balance is automatically adjusted
in a specific environment. In order to obtain the best result, press the SET button while
the camera focuses on white paper. If the environment including the light source is
changed, you have to adjust the white balance again.
Manual: To fine adjust, select the Manual mode. You can increase or decrease
the red or blue factor while monitoring the difference on the screen. Set to 'Manual'
mode and press the SET button. Increase or decrease the value for red(R-Gain)
and blue(B-Gain), watching the color of the picture, and press the SET button
when you obtain the best color.
Notes
• Proper White Balance may not be obtained under the following conditions, in these
cases select the AWC mode.
When the scene contains mostly high color temperature object, such as a blue
sky or sunset.
When the scene is dim.
If your camera faces fluorescent lamp directly or is installed in the place of the
changing illumination.

Motion Detection

Your camera transmits an alert signal when it detects motion of an object on the
screen. If you connect the camera to an external alarm, you can pay attention to
the screen when the alarm sounds.
COLOR CCD CAMERA 28 User's Manual
This feature is useful when you have to monitor several screens simultaneously.
Whenever your camera detects motion of object displaying 'Motion Detected'
with the number counted up on the screen.
1. Press the SET button to display the setup menu and move the arrow
indicator to 'Motion Det.' using the UP or DOWN button.
2. Set 'Motion Det.' to the desired mode using LEFT or RIGHT button.
Setup
Camera ID OFF
Backlight WDR
White Bal. W-ATW
Motion Det. OFF
Lens DC
Shutter OFF
MD1: Your camera detects the object's motion by outline or difference of a
color tone, so this mode is very useful for the daytime or observing
small moving object.
Press SET button.
Move the arrow indicator to 'Area Set' using UP and DOWN button, and
then press the SET button.
Set the areas you want to observe.
· You can adjust the top, bottom, left and right base lines by 13 steps
from top to bottom, 18 steps from left to right with an increment of 1.
COLOR CCD CAMERA 29 User's Manual