Table of Contents
Advertisement
34
FEATURES FOR RECORDING
EN
LED Light
LED Light can be used to
brighten the subject in the dark
place during video recording or
D.S.C. shooting.
1
Press LIGHT repeatedly to change the
setting.
The light is on always. (
The light turns on automatically
when dark. (
Turns off the light.
2
Press the Recording Start/Stop Button to
start video recording or SNAPSHOT to shoot a
still image.
NOTES:
Be careful not to point the LED Light directly to
eyes.
If the light does not reach the subject when the
LED Light setting is "ON", the Night-Alive
function will be activated, and makes it possible
to shoot the subject brighter.
Since subjects are shot at a reduced shutter
speed when the LED Light setting is "ON", they
will appear slightly blurred.
LIGHT
LED Light
appears.)
appears.)
Snapshot (Record Still Image On
Tape)
This feature lets you record still images that
look like photographs onto a tape.
1
Set the VIDEO/MEMORY Switch to
"VIDEO".
2
Set the Power Switch to "REC".
3
Set the recording mode to "
4
Set "REC SELECT" to
(
pg. 31)
"
".
5
Press SNAPSHOT.
"PHOTO
The
" indication appears and a still image
will be recorded for approx. 5 seconds, then the
camcorder re-enters the Record-Standby mode.
You can perform Snapshot also during
recording. A still image will be recorded for
approx. 5 seconds, then the normal recording
resumes.
Snapshot is effective when the recording mode
selection is set to both
If the image taken by snapshot is too dark or too
bright, select
(
(
pg. 38).
The image size for snapshot in 16:9 mode is
640 x 360. However, the approximate number of
storable images is similar with snapshot in 4:3
mode. (
pg. 24)
Motor Drive Mode
Keeping SNAPSHOT pressed in step 5
provides an effect similar to serial
photography. (Interval between still
images: approx. 1 second)
The Motor Drive mode is disabled when "REC
SELECT" is set to "
(
pg. 31)
M
". (
pg. 20)
"
/
" or
A
M
"
"
"
".
or
pg. 36) or "SPOTLIGHT"
/
" or "
".
Hide quick links:
Advertisement
Table of Contents
