Audio Dubbing; Insert Editing - JVC GR-D790U Instructions Manual

Audio Dubbing

The audio track can be customized only when
recorded in the 12-BIT and SP modes.
( pg. 33)
Use the provided remote control.
Speaker
START/
STOP
PAUSE
PLAY
REW
STOP
INSERT
A.DUB
1
Play back the tape to locate the point where
editing will start, then press PAUSE (8).
2
While holding A. DUB (
control, press PAUSE (8). The "8
appears.
3
Press PLAY (3), then begin "narrating".
Speak into the microphone.
To pause dubbing, press PAUSE (
4
To end Audio Dubbing, press PAUSE (8),
then STOP (7).
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX"
( pg. 35).
NOTES:
Sound is not heard from the speaker during
Audio Dubbing.
When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are
recorded separately.
If feedback or howling occurs during TV
playback, move the camcorder's microphone
away from the TV, or turn down the TV's volume.
You can record a new scene into a previously
recorded tape, replacing a section of the
original recording with minimal picture
distortion at the in and out points. The original
audio remains unchanged.
NOTES:
Stereo
Microphone
1
and press PAUSE (8). Confirm the time code
at this point. (
2
) on the remote
located, then press PAUSE (8).
" indicator
3
control, then press PAUSE (8). The "8
indicator and the Time Code (min.:sec.)
8
appear and the camcorder enters Insert-Pause
).
mode.
4
5
then STOP (7) on the remote control.
NOTES:

Insert Editing

Use the provided remote control.
Before performing the following steps, make
sure that "TIME CODE" for "DISPLAY" in both
Recording and Playback Menus is set to "ON".
( pg. 34, 35)
Insert Editing is not possible on a tape recorded
in the LP mode or on a blank portion of a tape.
Play back the tape, locate the Edit-Out point
pg. 20)
Press REW (1) until the Edit-In point is
Press and hold INSERT (
Press START/STOP to begin editing.
Confirm the insert at the time code you checked
in step 1.
To pause editing, press START/STOP. Press it
again to resume editing.
To end Insert Editing, press START/STOP,
Program AE, Effects and Shutter Effects
( pg. 41) can be used to spice up the scenes
being edited during Insert Editing.
During Insert Editing, the date and time
information changes.
If you perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops.
45
EDITING
EN
) on the remote
"