Dubbing To Or From A Video Unit Equipped With A Dv Connector (Digital Dubbing) - JVC GR-D750U Instructions Manual

32 EDITING
EN
Dubbing To Or From A Video Unit
Equipped With A DV Connector
(Digital Dubbing)
It is also possible to copy recorded scenes
from the camcorder onto another video unit
equipped with a DV connector. Since a digital
signal is sent, there is little, if any, image or
sound deterioration.
Core filter
Video unit equipped with DV connector
To use this camcorder as a player
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit
equipped with a DV input connector using a DV
cable as shown in the illustration.
3
Start playback on the camcorder.
( pg. 19)
4
At the point you want to start dubbing, start
recording on the video unit. (Refer to the video
unit's instruction manual.)
5
To stop dubbing, stop recording on the
video unit, then stop playback on this
camcorder.
To DV IN/OUT
DV cable (optional)
To DV IN/OUT
NOTES:
It is recommended to use the AC Adapter as
the power supply instead of the battery
pack. ( pg. 13)
If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not
dubbed.
Even though the DV cable is connected
correctly, sometimes the image may not appear
in step 4. If this occurs, turn off the power and
make connections again.
If SNAPSHOT is pressed during playback, only
the original playback image recorded on the
tape is output from the DV IN/OUT connector.
When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U
DV cable.
To use this camcorder as a recorder
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit
equipped with a DV output connector using a
DV cable as shown in the illustration.
3
Set the camcorder's Power Switch to
"PLAY".
4
Set "REC MODE" to "SP" or "LP".
( pg. 25)
5
Start playback on the player.
6
Press the Recording Start/Stop Button to
engage the Record-Pause mode.
•
The " " indication appears on the
DV IN
screen.
7
At the point you want to start dubbing, press
the Recording Start/Stop Button to start
dubbing. The indication rotates.
8
Press the Recording Start/Stop Button
again to stop dubbing. The
stops rotating.
9
Press 7 to return to the normal playback
mode.
NOTE:
Digital Dubbing is performed in the sound mode
recorded on the original tape, regardless of the
current "SOUND MODE" setting. (
COPY PROTECTED
Appears if dubbing of copyguarded signals is
attempted while this camcorder is being used
as a recorder.
indication
pg. 24)