Power - JVC GR-D340E/EK Instructions Manual

GETTING STARTED
12
EN
How To Attach The Lens Cap
To protect the lens, attach
the provided lens cap to the
camcorder as shown in the
illustration.
NOTE:
To confirm the lens cap is on
correctly make sure the cap is
flush to the camcorder.
Place here during
shooting.
How To Attach The Shoulder Strap
Follow the illustration.
1
Thread the strap through the eyelet.
2
Fold it back and thread it through the strap
guide and the buckle.
To adjust the length of the strap, loosen and then
tighten the strap in the buckle.
3
Slide the strap guide fully towards the eyelet.
Strap guide
1
Eyelet
Buckle
2
2

Power

This camcorder's 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging The Battery Pack
Battery pack
Arrow
To DC
connector
AC Adapter (ex. AP-V17E
1
Set the Power Switch to "OFF".
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against
the battery pack mount a.
3
Slide down the battery pack until it locks in
place b.
4
Connect the AC Adapter to the camcorder.
5
Connect the Power Cord to the AC Adapter.
(AP-V14E only)
6
Plug the AC Adapter into an AC outlet. The
3
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
7
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.
Battery pack mount
To AC outlet
Power
switch
PUSH
BATT.
POWER/
CHARGE
lamp
)