Viewfinder Adjustment; Brightness Adjustment Of The Display; Tripod Mounting - JVC GR-D33 Instructions Manual

Viewfinder Adjustment

1
Set the Power Switch to "A" or "M" while pressing
down the Lock Button located on the switch.
2
Make sure the LCD monitor is closed and locked. Pull
out the viewfinder fully and adjust it manually for best
viewability.
3
Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused.
PAUSE
CAUTION:
When retracting the viewfinder, take care not to pinch your
fingers.
Diopter Adjustment Control

Brightness Adjustment Of The Display

1
Set the Power Switch to "M"
or "PLAY" while pressing down
the Lock Button located on the
switch.
2
Open the LCD monitor fully.
( pg. 12)
3
Press the MMENU/VOL.
Wheel in. The Menu Screen
appears.
4
Rotate the MMENU/VOL.
Wheel to select "n", and
press it. The CAMERA
DISPLAY Menu appears.
5
Rotate the MMENU/VOL.
Wheel to select "BRIGHT", and press it. The Menu
Screen closes and the brightness control indicator
appears.
6
Rotate the MMENU/VOL. Wheel until the appropriate
brightness is reached.
7
Press the MMENU/VOL. Wheel in.
It is also possible to adjust the brightness of the viewfinder
by pulling out the viewfinder, setting "PRIORITY" in the
SYSTEM Menu to "FINDER" (
as described above.

Tripod Mounting

To attach the camcorder to a
tripod, align the direction stud
and screw to the mounting
socket and stud hole on the
camcorder. Then tighten the
screw clockwise.
Some tripods are not
equipped with studs.
CAUTION:
When attaching the camcorder
to a tripod, extend its legs to
stabilize the camcorder. It is not advised to use small sized
tripods. This may cause damage to the unit by falling over.
GETTING STARTED
EN
MMENU/VOL.
BRIGHT
pg. 25, 27) and adjusting
9