Table of Contents
Advertisement
Time Code
During recording, a time code is recorded on the tape.
This code is to confirm the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion, the time code
begins counting from "00:00:00" (minute:second:frame).
If recording starts from the end of a previously recorded
scene, the time code continues from the last time code
number.
If during recording a blank portion is left partway
through the tape, the time code is interrupted. When
recording is resumed, the time code starts counting up
again from "00:00:00". This means the camcorder may
record the same time codes as those existing in a
previously recorded scene. To prevent this, perform
"RECORDING FROM THE MIDDLE OF A TAPE" in the
following cases;
• When shooting again after playing back a recorded
tape.
• When power shuts off during shooting.
• When a tape is removed and re-inserted during
shooting.
• When shooting using a partially recorded tape.
• When shooting on a blank portion located partway
through the tape.
• When shooting again after shooting a scene then
opening/closing the cassette holder cover.
Display
12 : 34 : 24
Frames are not displayed
during recording.
RECORDING FROM THE MIDDLE OF A TAPE
1
Play back a tape or use Blank Search (
find the spot at which you want to start recording, then
engage the Still Playback mode (
Playback").
2
Set the Power Switch
pressing down the Lock Button
switch, then start recording.
NOTES:
The time code cannot be reset.
During fast-forwarding and rewinding, the time code
indication does not move smoothly.
The time code is displayed only when "TIME CODE" is
set to "ON" (
pg. 24).
TAPE RECORDING
Minutes
Seconds
Frames
(30 frames = 1 second)
pg. 14) to
pg. 13, "Normal
r
to "
" or "
" while
e
located on the
Normal Playback
1
Load a tape (
pg. 9).
2
Set the Power Switch
e
down the Lock Button
6
playback, press 4/6
.
• To stop playback temporarily (Still Playback), press
6
.
4/6
• To stop playback, press 5
5
• Press 2
to rewind, or 3
tape during Stop mode.
• High-speed picture search (Shuttle Search) is
possible by pressing 2
5
7
(holding 2
or 3
continues search until released).
• At any time, pressing 4/6
playback.
To Control The Speaker Volume:
Rotate the MENU/VOLUME wheel
i
volume level indicator
obtain the appropriate volume.
ATTENTION
During Shuttle Search, parts
of the picture may not be
clearly visible, particularly on
the left side of the screen.
5
6
4
7
Speaker
r
to "PLAY" while pressing
located on the switch. To start
4
.
7
to fast-forward the
5
7
or 3
during playback
down during playback
6
resumes normal
#
so that the
on the display moves to
#
e
r
Continued on next page.
TAPE PLAYBACK
EN
13
Hide quick links:
Advertisement
Table of Contents
