How To Attach The Core Filter; Automatic Demonstration - JVC GR-D31US Instructions Manual

Attach the Core Filter(s) (if provided with your model
interference.
1
Stopper
Release the
stoppers on both
ends of the Core
Filter.
When connecting cables, attach the end with the Core Filter to the camcorder.
Automatic Demonstration takes place when
"DEMO MODE" is set to "ON" (factory-preset).
Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch
and no cassette is in the camcorder.
Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
"DEMO MODE" remains "ON" even if the camcorder power is
turned off.
To cancel Automatic Demonstration:
1. Set the Power Switch
e
Button located on the switch and press the MENU/VOLUME
#
wheel in. The Menu Screen appears.
2. Rotate the MENU/VOLUME wheel
and press it.
3. Rotate the MENU/VOLUME wheel
and press it. The Sub Menu appears.
4. Rotate the MENU/VOLUME wheel
it.
5. Rotate the MENU/VOLUME wheel
and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
EN
6

HOW TO ATTACH THE CORE FILTER

2
3 cm
Run the cable through the Core Filter, leaving approx. 3 cm
of cable between the cable plug and the Core Filter. Wind
the cable once around the outside of the Core Filter as
shown in the illustration.
• Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.

AUTOMATIC DEMONSTRATION

r
to " " while pressing down the Lock
#
#
#
#
pg. 5) to an optional cable(s). The Core Filter reduces
Wind once
r
is set to " " or "
to select " (SYSTEM)"
to select "DEMO MODE"
to select "OFF" and press
to select " RETURN",
3
Close the Core Filter until it
clicks shut.
#
"
e
r
S Y
D EMO MODE
RETURN
Sub Menu
S TEM
– OF F
ON
None