Make Electrical Connection - IKEA UNDERCOUNTER DISHWASHER PLASTIC GIANT TUB MODELS Installation Instructions Manual

Make Electrical Connection

Check "Electrical Requirements" section.
You need to:
■ have the correct electrical supply and recommended
grounding method.
If you are:
■
direct wiring use Option 1.
■ using a power supply cord, use Option 2.
Option 1: Direct Wiring
1. Route direct wire so that it does not touch dishwasher motor
or lower part of dishwasher tub.
2. Pull direct wire through hole in terminal box.
Helpful Tip:
■ Select the proper size twist-on
connectors to connect your
household wiring to 16-gauge
dishwasher wiring.
■ Insert wire ends into twist-on
connector. Do not pre-twist bare
wire.
■ Twist connector.
■
Gently tug on wires to be sure both
are secured.
3. Connect the wires as follows using
twist-on connectors sized to
connect direct wire to 16-gauge dishwasher wire.
Power supply wire:
white
black
ground wire
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Terminal box wire:
↔
white
↔
black
↔
ground connector
4. Form bare ground wire into a U-shaped hook. Wrap ground
wire hook clockwise around ground connector and under the
washer.
5. Securely tighten ground connector.
A
B
C
A. Ground wire
B. Washer
C. Ground connector
6. Tighten clamp connector or conduit connector screws.
A
7. Reinstall terminal box cover with wires inside terminal box.
The cover must be outside the box on the left side.
ADVERTENCIA
AVERTISSEMENT
8. Make sure no wires are pinched by the cover.
A. Screws
17