Page 1
If you are unclear on any point, contact your dealer or BOB before use. For a list of dealers, visit www.bobgear.com or call (800) 893-2447. OMA46B...
• Failure to properly assemble or handlebar or frame of stroller except install the quick release wheels on those recommended by BOB, as this stroller may result in the wheels stroller can become unstable and tip becoming detached while moving and over.
Page 18 CARE AND MAINTENANCE Page 19 STORAGE Page 19 CARGO Page 19 STROLLER ACCESSORIES Page 19 LIMITED WARRANTY Page 20 BOB IS NOT RESPONSIBLE FOR INJURY, DEATH, DAMAGE OR FAILURE THAT RESULTS FROM OWNER’S FAULTY ASSEMBLY, USE OR MAINTENANCE. OMA46B...
Brake Caliper Low Boy Assembly Cargo Basket CONGRATULATIONS Congratulations on your purchase Wrist Strap of the BOB Sport Utility Stroller ® or IRONMAN Stroller. ® Seat Back Pocket For updates to this manual, warranty and other recent product Frame Release notifications, please visit www.
BOB recommends that children will need to attach the fender. should be at least 8 weeks old before riding in a BOB stroller without a 1. Remove Mounting Screws BOB Infant Car Seat Adapter and Two fender mounting screws can be compatible infant car seat.
The front wheel is correctly clamped quick release can allow the wheel in place by the force generated when to vibrate, wobble or become the quick release lever is closed detached from the stroller. This can and the cam action pulls the lever result in serious injury or death.
Page 7
Tension Adjusting Nut To properly close the quick release and secure the rear wheel in the dropouts, confi rm the axle is fully inserted in the dropout, while maintaining the wheel in this position, rotate the quick release toward stroller and into the FULLY CLOSED position.
the quick release has not been To LOOSEN tension adjusting nut, properly tightened and adjusted. The turn counterclockwise. secondary retention devices are backup systems and are not intended as a substitute for a properly FULLY CLOSED adjusted quick release. The secondary retention devices on your stroller are the integral type that are formed into the outer faces of the...
Quick Release Lever FRONT WHEEL INSTALLATION FULLY OPEN FULLY CLOSED 1. Install Front Wheel Quick Re- lease Lever Remove Tension Adjusting Nut from quick release rod and take off fi rst spring. Slide quick release rod through front wheel axle, place 4.
the brake quick release lever by Fork Blade squeezing the brake pads against FULLY CLOSED the wheel with one hand, then rotate the brake quick release lever in the counter clockwise direction with your other hand until it points downward. Brake Quick Release FULLY OPEN Dropouts...
Page 11
If you are not familiar with how to use the To tighten the cable, loosen the lock barrel adjusters, please contact BOB ring and turn the barrel adjuster in customer service or visit your local the counter clockwise direction.
UNFOLD STROLLER Care must be taken when folding and unfolding the stroller to prevent fi nger entrapment or injury. SNAP To avoid injuries, never fold or unfold stroller with other individuals within reach of stroller. 1. Lift Red Frame Release Handle Keep tires on ground as stroller swing FOLD STROLLER arm begins to swing open.
STROLLER ADJUSTMENTS CHECK TIRE PRESSURE Plastic wheels are rated to a maximum tire infl ation pressure of 30 pounds per square inch (psi). The maximum infl ation pressure is embossed on the wheel next to the valve stem. Infl ating tires above 30 psi can damage the wheel and/ or tire resulting in loss of control and injury.
Position 1: Child 40 pounds or less 5. Test Alignment 40 lbs Push stroller straight forward and release to see if stroller veers right or SNAP left. Repeat push test several times. Position 2: Child 41 to 70 pounds 70 lbs NOTE: If stroller consistently pulls to left or right, the tracking can often be corrected by simply rotating the...
wheel and fl ip it around so the quick release lever is on the opposite side. Reinstall the front wheel, secure the wheel and brake quick release levers. See Removing Front Wheel and Front Wheel Installation sections. RIGHT Knob 3. Perform Roll Test Repeat Roll test.
is 44 inches or (112 cm). Do not used to slow or stop the stroller because doing so could cause the exceed the maximum weight or height, as stroller will become stroller to stop abruptly, resulting unstable. in loss of control. Do not park on Avoid serious injury inclines.
4. Adjust Shoulder Strap Height Secure Wrist Strap Adjust height of shoulder strap to fi t Slip loop of strap securely onto wrist. just above child shoulder height. 5. Adjust Shoulder Straps Open Velcro pads. Slide buckle up or down to adjust straps. Seat harness should fi...
When seat is fully ACCESSORY ADAPTER reclined, backward tip over is more likely to occur and may result in an This BOB stroller is equipped with accident or injury, as seat and/or an accessory adapter providing passenger may contact ground easy attachment for BOB Stroller before handlebar.
The BOB Infant Car Seat Adapter allows you to easily attach leading Adding weight to infant car seat models to a BOB the seat back changes the center Stroller utilizing the BOB Accessory of gravity of the stroller, and Adapter feature.
This and fl ying insects. warranty is limited to the repair or DIAPER BAG replacement of the defective part. Clips directly to all BOB single and BOB shall in no event be responsible Duallie ® strollers. Shoulder strap,...
Need help?
Do you have a question about the Ironman and is the answer not in the manual?
Questions and answers