Summary of Contents for BOB SPORT UTILITY STROLLER
Page 1
® BOB Gear by Britax (03) 9288-7288 www.britax.com.au 99 Derby Road, Sunshine, Victoria 3020 SPORT UTILITY STROLLER IRONMAN ENGLISH Owner’s Instruction Manual TAKE TIME READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY! Before attempting to assemble or use your new stroller, read and understand these...
• The stroller is not equipped for use in stroller except those recommended by low light or after dark. BOB, as stroller can become unstable • Failure to properly assemble or and tip over. install the quick release wheels on • Do not place sharp objects in the seat...
Page 3
• It is unsafe to use accessories other than those tested and approved by BOB. For maximum safety only use accessories designed for this stroller. IMPORTANT •...
Page 19 Accessory Adapter Page 19 CARE AND MAINTENANCE Page 20 STORAGE Page 20 CARGO Page 20 STROLLER ACCESSORIES Page 20 BOB IS NOT RESPONSIBLE FOR INJURY, DEATH, DAMAGE OR FAILURE THAT RESULTS FROM OWNER’S FAULTY ASSEMBLY, USE OR MAINTENANCE. OMB22...
Brake Caliper Low Boy Assembly Cargo Basket CONGRATULATIONS Congratulations on your purchase Wrist Strap of the BOB Sport Utility Stroller ® or IRONMAN Stroller. ® Seat Back Pocket For updates to this manual, warranty and other recent product Frame Release notifications, please visit www.
BOB recommends that children will need to attach the fender. should be at least 8 weeks old before riding in a BOB stroller without a 1. Remove Mounting Screws BOB Infant Car Seat Adapter and Two fender mounting screws can be compatible infant car seat.
The front wheel is correctly clamped quick release can allow the wheel in place by the force generated when to vibrate, wobble or become the quick release lever is closed detached from the stroller. This can and the cam action pulls the lever result in serious injury or death.
Page 8
Tension Adjusting Nut To properly close the quick release and secure the rear wheel in the dropouts, confirm the axle is fully inserted in the dropout, while maintaining the wheel in this position, rotate the quick release toward stroller and into the FULLY CLOSED position.
To LOOSEN tension adjusting nut, the quick release has not been properly tightened and adjusted. The turn counterclockwise. secondary retention devices are backup systems and are not intended as a substitute for a properly FULLY CLOSED adjusted quick release. The secondary retention devices on your stroller are the integral type that are formed into the outer faces of the...
FRONT WHEEL INSTALLATION Quick Release Lever FULLY OPEN FULLY CLOSED 1. Install Front Wheel Quick Re- lease Lever Remove Tension Adjusting Nut from quick release rod and take off first spring. Slide quick release rod through front wheel axle, place 4.
the brake quick release lever by Fork Blade squeezing the brake pads against FULLY CLOSED the wheel with one hand, then rotate the brake quick release lever in the counter clockwise direction with your other hand until it points downward. Brake Quick Release FULLY OPEN Dropouts...
Page 12
NOTE: For the hand brake to work CALIPER BRAKE correctly, it is critical that it be Brake Caliper Mounting Nut adjusted properly. Squeeze the brake lever and verify that the brake pads Barrel Adjuster contact the rim. Verify brake quick release is in closed position.
UNFOLD STROLLER Care must be taken when folding and unfolding the stroller to prevent finger entrapment or injury. SNAP To avoid injuries, never fold or unfold stroller with other individuals within reach of stroller. 1. Lift Red Frame Release Handle Keep tires on ground as stroller swing FOLD STROLLER arm begins to swing open.
STROLLER ADJUSTMENTS CHECK TIRE PRESSURE Plastic wheels are rated to a maximum tire inflation pressure of 30 pounds per square inch (psi) or 206.8 kilo pascal (kpa). The maximum inflation pressure is embossed on the wheel next to the valve stem. Inflating tires above 30 psi can damage the wheel and/ or tire resulting in loss of control...
Position 1: Child 18 kgs or less perpendicular to a straight line. 18 kgs 5. Test Alignment Push stroller straight forward and SNAP release to see if stroller veers right or left. Repeat push test several times. Position 2: Child 18 to 25 kgs 25 kgs NOTE: If stroller consistently pulls to left or right, the tracking can often...
wheel and flip it around so the quick release lever is on the opposite side. Reinstall the front wheel, secure the wheel and brake quick release levers. See Removing Front Wheel and Front Wheel Installation sections. RIGHT Knob 3. Perform Roll Test Repeat Roll test.
used to slow or stop the stroller Use harness because doing so could cause the at all times. stroller to stop abruptly, resulting in loss of control. Never leave your child in the stroller unattended Do not park on with or without the parking brake inclines.
4. Adjust Shoulder Strap Height Secure Wrist Strap Adjust height of shoulder strap to fit Slip loop of strap securely onto wrist. just above child shoulder height. 5. Adjust Shoulder Straps Open Velcro pads. Slide buckle up or down to adjust straps. Seat harness should fit snug and be comfortable.
When seat is fully ACCESSORY ADAPTER reclined, backward tip over is more likely to occur and may result in an This BOB stroller is equipped with accident or injury, as seat and/or an accessory adapter providing passenger may contact ground easy attachment for BOB Stroller before handlebar.
Safe N Sound infant car seat increases the possibility that it will models to a BOB Stroller utilizing the tip over backwards, resulting in BOB Accessory Adapter feature. injury. For this reason, loads in the...
Page 21
SNACK TRAY The Snack Tray easily inserts into any BOB Stroller utilizing the BOB Accessory Adapter feature, placing snacks and sippy cups at your child’s fingertips. BOB, BOB Strollers, Stroller Strides,...
Need help?
Do you have a question about the SPORT UTILITY STROLLER and is the answer not in the manual?
Questions and answers