Adjustment Of Vcr/Camcorder Timing; Diagnosing Vcr/Camcorder Timing - JVC GR-D200 Instructions Manual

For More Accurate Editing
Some VCRs make the transition from Record-Pause
to Record mode faster than others. Even if you begin
editing for the camcorder and the VCR at exactly the
same time, you may lose scenes you wanted, or find
that you have recorded scenes you did not want. For
a cleanly edited tape, confirm and adjust the timing
of the camcorder against your VCR.

Diagnosing VCR/Camcorder Timing

1
Play back the tape in the camcorder, then point
the remote control at the camcorder's remote
sensor and press R.A.EDIT ON/OFF.
Random Assemble Editing Menu appears.
Program 1
N I OUT MODE
1 – – – – : – – ~
2 ~
3 ~
4 ~
5 ~
6 ~
~
7
8 ~
T I ME CODE – – : – –
TOTAL 0 0 : 00
2
Perform Random Assemble Editing on Program 1
only. In order to check VCR and camcorder
timing, select the beginning of a scene transition
as your Edit-In point.
3
Play back the dubbed scene.
If any images from the scene prior to the
transition you chose for your Edit-In point were
recorded, that means your VCR moves too
quickly from Record-Pause to Record mode.
If the scene you tried to dub starts in progress,
the VCR is slow to start recording.
Random Assemble
Editing Menu

Adjustment Of VCR/Camcorder Timing

4
Press R.A.EDIT ON/OFF to make the Random
Assemble Editing menu disappear, then press
MENU. The Menu Screen appears.
5
Press + or – to select "t VIDEO", and press
SELECT/SET. The VIDEO Menu appears.
6
Press + or – to select "SYNCHRO", and press
SELECT/SET. The value for "SYNCHRO" is
highlighted.
7
Based on the diagnostics performed, you can
now advance the VCR's record timing by pressing
+. You can also delay the VCR's record timing by
pressing –.
The adjustment range is from –1.3 to +1.3
seconds, in 0.1-second increments.
Press SELECT/SET to finish the setting.
8
Press + or – to select "BRETURN", and press
SELECT/SET twice.
Now perform Random Assemble Editing
beginning with step 6 on page 63.
NOTES:
Before performing actual Random Assemble
Editing, do a few Random Assemble Editing trial
runs to check whether the value you have input is
appropriate or not, and make adjustments
accordingly.
Depending on the recorder, there may be
situations where the timing difference cannot be
fully corrected.
$# $# $# $#
   
EN EN EN EN