9.
Secure the front end of the accelerator
to the bracket with one screw.
10.
Repeat steps 3—9 if you need to install
a second accelerator to the bracket.
11.
Align and insert the golden fingers of
the accelerator bracket into the card slot
on the motherboard. Ensure the bracket
is completely seated on the slot.
12.
Attach the white end of the 4-pin power
cable to an available 4-pin power
connector in front of the accelerator
bracket.
13.
Secure the thumbscrew in front of the
accelerator bracket.
2-28
Chapter 2: Hardware setup