Table of Contents
Advertisement
Using New Configuration
When a RAID set already exists, using the New Configuration command erases the existing
RAID configuration data. If you do not want to delete the existing RAID set, use the View/
Add Configuration command to view or create another RAID configuration.
To create a RAID set using the New Configuration option
1.
From the Management Menu, select Configure > New Configuration, and then press
<Enter>.
Management Menu
Configure
Initialize
Objects
Rebuild
Check Consistency
Use Cursor Keys To Navigate Between Items And Press Enter To Select An Option
2.
Follow step 2 to 9 of the previous section: Using Easy Configuration.
3.
Select Size from the Virtual Drive menu, and then press <Enter>.
4.
Key-in the desired virtual drive size, and then press <Enter>.
Management Menu
Configure
Initialize
Objects
Rebuild
Check Consistency
Use Cursor Keys To Navigate Between Items And Press Enter To Select An Option
5.
Follow step 10 to 14 of the previous section: Using Easy Configuration to create the
RAID set.
6-10
LSI Software RAID Configuration Utility Ver C.05 Sep 17,2010
BIOS Version
Configuration Menu
Easy Configuration
New Configuration
View/Add Configuration
Clear Configuration
Select Boot Drive
Clear Existing Configuration And Start A New Configuration
LSI Software RAID Configuration Utility Ver C.05 Sep 17,2010
BIOS Version
Virtual Drive(s) Configured
Easy Configuration - ARRAY SELECTION MENU
LD
RAID
Size
0
1
148.580GB
0
1
Enter VD Size: 152146_
Virtual Drive 0
2
RAID = 1
3
Units= MB
Size = 152146MB
DWC
= OFF
RA
= On
Accept
SPAN = NO
Enter VD Size:
A.10.09231523R
A.10.09231523R
#Stripes
StripSz
PORT #
2
64KB
ONLIN A00-00
ONLIN A00-01
READY
READY
Status
ONLINE
Chapter 6: RAID configuration
Advertisement
Table of Contents
